Does The Furrion LED Marker Light Side Cameras FCE48TASL Use LED Side Marker Lights?

Question

Question:

Looking for LED Marker Lights/Camera for Furrion Vision S 7. Item FCE48TASL says that is the LED version but Amazon saying FCE48TASH is the led version. The current marker light is LED and Ive read there are some issues using the standard incandescent bulb version. Can you confirm if the above link is the LED version? Thanks.

asked by: Andy P

0

Expert Reply:

The LED Marker Light RV Side Cameras w/ Night Vision for Furrion Vision S Systems # FCE48TASL you mentioned does use LEDs for the night vision function, but the side marker lights use incandescent bulbs. Even the FCE48TASH you mentioned uses the same incandescent bulbs.

With that said the # FCE48TASL will still work to replace the LED side marker lights as they only pull .25 amps with the night vision mode turned off, or .5 amps with the night vision on, but to make sure you are not overloading the running light circuit on your vehicle you would need to add up the amp draw from all of the lights on the running light circuit and make sure the total amp draw does not exceed the amp rating of your running light circuit. Since you have all LED lights it is unlikely you will exceed the amp rating by using the # FCE48TASL.

The # FCE48TASL will up perfectly with the Furrion Vision S Wireless RV Backup Camera System w/ Night Vision # FOS05TASF you mentioned you have.

I included videos for each of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

That is an alternate number that we are aware of for the #FCE48TASL but we decided to keep the old number.

view full answer...

Answer 2

The angle of the Furrion side marker cameras in the kit part #FCE48TASL isn't adjustable. It's set at an angle that when you have it installed on the front of the trailer you'll see a small portion of the trailer and as wide…

view full answer...

Answer 3

Yes, you can swap out your cap sensors for internal sensors and they will work with your current TST-507-RV-4 system. We offer the internal sensors individually with part #TST-507-INT-S1. Definitely a good idea if you don't want to have to worry…

view full answer...

Answer 4

If one of the sensors in your TST TPMS #TST-507-INT-6-C is randomly turning off/on and only reading 1 or 00 for the tire pressure that leads me to believe the battery is dying and not allowing the sensor to properly operate. The batteries are…

view full answer...

Answer 5

According to my contact at TST, going with the internal sensor would have the following benefits: • Battery Life. The internal sensors can be expected to last 5+ years, versus about 1 to 1-1/2 years for the external. • Protection: By virtue of the…

view full answer...

Answer 6

According to TST, once the repeater is installed, the sensors included with the #TST-507-INT-6-C will work within 5 minutes. My representative tells me that the expected battery life is 3-5 years, and once the battery goes dead, the sensor itself…

view full answer...

Answer 7

Since you have dually tires I recommend looking at a setup like the TST TPMS #TST-507-INT-6-C which uses internal tire sensors that secure around the wheel instead of connecting to the valve stem. Some additional benefits to this kind of setup…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...