Is There a Replacement Strap for the Curt Echo

Question

Question:

looking for a REPLACEMENT ECHO BRAKE CONTROLLER STRAP #51186. Any chance you know where I can find one ?

asked by: Bruce A

0

Expert Reply:

We have the Replacement Echo Brake Controller Strap, part # C28HR, here. This will replace the strap on your Curt Echo, part # C51180.

expert reply by: Kef G

0

Answer 1

The RVP air conditioner model 8333D876 is a Coleman Mach 3 according to my research. With that said, you can use Furrion Chill Replacement RV Air Conditioner for Furrion Setup part #FR86PR with the wiring adapter part #C-FACR15SA-A01 to hook up the…

view full answer...

Answer 2

The Round Swivel Marine Jack w/ Wheel - Bolt On - Zinc - Sidewind - 10" Travel - 1,000 lbs #MJ-1206B can absolutely be installed on the tongue part of the trailer. The video you are referring to I have attached and it wasn't added to the…

view full answer...

Answer 3

For the Curt RockerBall Shock Absorbing Gooseneck Hitch Ball #C67DR, you will want to use a high quality molybdenum-based grease. You will want to grease prior to initial use and once every 3 months or 3,000 miles.

view full answer...

Answer 4

The Curt Echo Trailer Brake Controller #C51180 won't itself provide any charge to your trailer mounted battery, but you certainly can still have a 12V power wire ran from the 7-Way to the battery for this purpose with the Echo in place. The Echo…

view full answer...

Answer 5

Yes, the Curt Echo Wireless Brake Controller #C51180 does allow 12V power to pass through the controller. With that being said, it will just be a trickle charge which is normal for a 7-Way even without this controller installed. Your trailer battery…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 10

A factory 7-way trailer connector isn't all you need to power a trailer's electric brakes. You still need a brake controller. Some Ford F-150s are equipped with a factory integrated brake controller, which you may have. If your 2012 Ford…

view full answer...

Answer 11

Sure thing, I will go ahead and list out what you need for your 2023 Kia Sportage to add a 7-way for a brake controller so you can tow with the Curt Trailer Hitch Receiver #C94WR: - T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector…

view full answer...

Answer 12

Hey Antoine, so the two kits you mentioned are actually really similar and honestly I would go with the part #ETBC7 if I were you. The #ETBC7L is basically the same thing minus a couple wires and breakers so you may as well get the kit that has…

view full answer...

Is There a Replacement Strap for the Curt Echo

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching