Installation of Curt C56079 Trailer Taillight Wiring Converter on 2010 Toyota Venza
Question:
got 90 of my 2010 Venza trailer harness installed. Your on line video was GREAT!. All that I have left is to hook up the wire to the positive post on the battery. Please give the crew that produced the video two thumbs up.
asked by: Randall T
Expert Reply:
Thank you very much! I'll pass that along to our video and install crew.
The best way to make that wiring run from the rear of the vehicle up to the battery would be to locate and follow an existing wiring harness under the vehicle, and zip tie the taillight converter power wire to that every couple of feet. You'll want to be sure to avoid anything moving or hot like suspension or exhaust components.
If you drive on gravel roads quite a bit, you might also consider a length of wire loom like # 7509-1 to protect the wire from road debris that might get kicked up as you drive over it.
![Mike L](https://images.etrailer.com/static/images/catg/people/166_tn.jpg)
Products Referenced in This Question
Wire Loom - 1/4" Diameter - 1' Long
- Wiring
- Wiring Protection
- Wire Loom
- 1/4 Inch Diameter
- Spectro
more information >
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How To Install Vehicle Wiring Harness Of 2013 Cadillac XTS
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: No Power to Brake Controller on a 2019 Honda Ridgeline
- Q&A: How to Find Connector for Back Up Sensors When Installing 118760 Trailer Wiring on 2019 Honda Pilot
- Article: Determining Trailer Tongue Weight
- Q&A: Troubleshooting Wiring Harness # 118482 on a 2011 Toyota Venza that Blows Fuses
- Q&A: Can Converter Box On Curt 4-Way Wiring Harness Go Bad
- Q&A: Installation Process for 4-Pole Trailer Wiring Harness 118482 in 2009 Toyota Venza
- Q&A: Does Exhaust have to be Lowered to Install Curt Trailer Hitch on a 2012 Toyota Venza All-Wheel Drive
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: Rooftop Cargo Carriers
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Trailer Wiring Diagrams