Do You Need To Make And Wiring Connections To Install The Curt T-Connector C55384
Question:
do you need to connect the red ground wire to the frame?
asked by: Barrie M
1
Helpful Expert Reply:
The Curt T-Connector Vehicle Wiring Harness for Factory Tow Package # C55384 you were looking at is designed for a vehicle with the factory tow package, and you will not need to ground any wires to the frame. It will simply plug in between the vehicle connector and factory connector as shown in the included video.
expert reply by:
Samuel C
1
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Measure for Trailer Hitch Drop
- Q&A: 2005 Chevy Silverado 2500 Short Bed Trailer Hitch Receiver Recommendation
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Is There an In Bed 7-Way Connector For The 2024 Toyota Tundra?
- Q&A: How Far Out Will Curt 15400 Extend on 2023 Ram 3500 Cab and Chassis
- Q&A: How to Tell if Dexter Axle 3,500 lb Electric Trailer Brakes Will Fit Axle
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)