How to Install Tail Light and Grommet into Trailer Light Mounting Bracket # BK70BB
Question:
Hi and thank you for your help.......I have purchased two led oval taillights for my trailer. I have a Tennesee trailer Model 2200...... I cannot for the life of me figure out how to get the actual light with the rubber seal to stay connected to the bracket. I have no problem fitting it in,but then it also has no problem falling out.... Please tell me what I am doing wrong....thanks
asked by: JAMES H
Expert Reply:
I went out to the warehouse and pulled a # BK70BB bracket, a 6 inch oval tail light and the A70GB grommet.
I found that it is much easier to install everything if you push the grommet fully into the bracket until it is fully seated and then push the light into the grommet until it bottoms out. At that point, you will have a fit tight enough that the lamp is securely held in place. Make sure the grommet is pushed FULLY into place before inserting the lamp.
Products Referenced in This Question
PVC Grommet for 6-1/2" Oval Trailer Tail Lights
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Grommet
- 6-1/2 Inch Long
- Oval
- Optronics
more information >
Product Page this Question was Asked From
Trailer Light Mounting Bracket for 6-1/2" Oval Trailer Lights, Steel - Black Powder Coat
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- 6-1/2 Inch Diameter
- Brackets
- Black
- Optronics
more information >
Continue Researching
- Shop: Dexter Disc Brake Kit - 12-1/4" Rotor - 8 on 6-1/2 - E-Coat - 8,000 lbs
- Shop: Replacement 13" Rotor for Dexter Disc Brakes - 8 on 6-1/2 - E-Coat - 8,000 lbs
- Shop: Caliper Rebuild Kit for 6,000-lb to 8,000-lb Dexter Disc Brakes
- Shop: Replacement Disc Brake Piston for Dexter 8,000-lb Caliper
- Shop: PVC Grommet for 6-1/2" Oval Trailer Tail Lights
- Shop: Trailer Light Mounting Bracket for 6-1/2" Oval Trailer Lights, Steel - Black Powder Coat
- Search Results: 22333
- Shop: Trailer Valet XL Trailer Dolly with Chain Drive - 2-5/16" Hitch Ball - 10,000 lbs
- Q&A: Mounting Dimensions of the Optronics 6-1/2 Inch Trailer Light # ST70RB
- Q&A: Can I Replace 8-14.5 Tires with a Non-Metric Sized Tire
- Shop: Vehicle Lights
- Video: Optronics Trailer Lights - Clearance Lights - STL75AMFB Review
- Q&A: How to Remove Flush Mount Taillights and Grommets in a Square Tube Snowmobile Trailer Frame
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Video: Trailer Wiring Harness Installation A35W42B
- Video: Optronics Wiring - Trailer Connectors - A35W42B Review
- Video: Redline Wiring - Tools for Wiring - 464600 Review
- Search Results: a46pb
- Search Results: wire clamps
- Search Results: mcl59ab
- Search Results: identification light bar
- Search Results: a86pb
- Search Results: a55gb
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Q&A: How to Cut a Grommet Hole for Installation of the Oval Trailer Tail Lights # STL22RB
- Shop: Trailer Wiring
- Video: Best 2021 Toyota Highlander Trailer Wiring Options
- Video: Optronics Trailer Lights - License Plate Lights - LPL31CB Review
- Video: Optronics Mini Trailer License Plate LED Light Review