Converting 6-Way to 7-Way on Motorhome With Separate Brake Lights & Turn Signals
Question:
2008 Winnebago Navion Iq. I went to swap out the original 6 pin to a standard 7 pin trailer connector and I’m sure you’ve heard this story 1000 times. My trailer brakes activated when I applied the brakes. I disconnected pin #2 everything works but my brake lights. Winn has separate brake turn signal lights. Is there a “box” I can wire in that will fix my Winn 6 pin to a standard 7 pin. Thanks Glenn
asked by: Glenn M
Expert Reply:
We can get you the right parts in order to convert the 6-way on your Winnebago motorhome to a standard 7-way. The 6-way will need to be replaced, and you will also need a converter, which may be the "box" you were referring to. The correct converter that will combine your brake lights and turn signals is the Roadmaster Brite-Lite Wiring Converter # RM-732.
I have added a link below to an install video and the instructions for the converter, and to ensure you have the right wires you are going to need a circuit tester if you don't have one, and I'd go with the Cordless Circuit Tester # PTW2979.
You will also need that because you will have to hardwire in the 7-way with the Hopkins Endurance Quick-Install 7-Way Trailer Connector with Universal Pigtail Harness - Vehicle End # HM47210.
I recommend connecting the wires of the 7-Way with the Heat Shrink Butt Connectors # DW05745-10.
I have added links below to videos and a help article on wiring for you to check out which may be helpful as well.
Products Referenced in This Question
Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 10
- Wiring
- Wire Connectors
- Butt Connectors
- 12-10 Gauge
- Deka
more information >
Hopkins Endurance Quick-Install 7-Way Trailer Connector with Universal Pigtail Harness - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug and Lead
- 7 Round - Blade
- Hopkins
more information >
Roadmaster Brite-Lite Wiring Converter
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal
- Roadmaster
more information >
Product Page this Question was Asked From
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Testing for Proper Voltage on the Brake Output Circuit
- Article: Trailer Wiring Diagrams
- Q&A: Can Electric Brake Controller Install and Function in Semi Truck with Air Brakes
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Replacement Circuit Board For Dometic Atwood Water Heater With Circuit Board 91346
- Q&A: No Power to 12 Volt on 7-Way of 2020 Ram 3500
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: What is Most Common Leaf Spring Length for 3,500 lb Trailer Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: How to Tell if 2019 Toyota Highlander Has Factory Tow Package
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting Brake Controller Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)