bing tracking image
Q & A Icon

Troubleshooting Ground Control RV Leveling System that Won't Reach Level  

Question:

Hi folks, I have a question about my 6 point auto level LCI system. Ive auto leveled but the unit is still not quite level. I read that I have to level my unit manually. Do I need to retract all my jacks before I manually level. If I do that how do I get the center stabilizer to go back down and stabilize the unit. I cant find this info in the LCI manual

0

Expert Reply:

Sounds like you need to set the zero point of your LCI Ground Control 6 point leveling system.

Here's how to do this:

The “Zero Point” is the programmed point that the trailer will return
to each time the Auto Level feature is used.

Note: Prior to starting this procedure, double check all connections
on the controller, jacks, and touch pad.

1. In manual mode, run the jacks to level the trailer. This is best
achieved by placing a level in the center of the trailer and leveling
it both front to back and then side to side. (See “Basic Jack
Operation” for instructions on how to manually operate the system).
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.
4. The touch pad will flash and beep and the display will read “ZERO
POINT CALIBRATION ENTER to set, Power to Exit”.
5. To set the current position as the zero point, press the “ENTER”
button.
6. LCD display will read “Zero point stability check”.
7. LCD display will read “Zero point set successfully” once process is
complete.
8. The system will set this point as its level state and the touch pad
will turn off.

expert reply by:
0
Jameson C

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>