Diameter of Hole That Runs Through Timbren Spring # TJFJ10
Question:
I need to know width of the mounting bolt holes for part number TJFJ10. Thank you
asked by: Paul F
0
Expert Reply:
The diameter of the hole that runs down the middle of the Timbren spring of part # TJFJ10 is 1/2 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Timbren Front or Rear Suspension Enhancement System
- Vehicle Suspension
- Front Axle Suspension Enhancement
- Rear Axle Suspension Enhancement
- Jounce-Style Springs
- Standard Duty
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Hitch Receiver Sizes
- Q&A: Length of Timbren Front Suspension Enhancement for 2006 Ford F-53 - EMAIL
- Q&A: Recommended Replacement RV Air Conditioner for 2020 Forest River Luxury Surveyor 33KRLOK
- Q&A: Air Bag Suspension Kit Recommendation for 2014 Ford F-250 with Gooseneck Hitch Installed
- Article: How (and Where) to Connect an RV Propane Grill
- Q&A: Does SumoSprings Custom Front Axle Helper Springs Part # CSS-1094F Fit on Stock Coil Springs
- Q&A: Does Timbren Kit TFRF53A Fit 2006 Forest River Georgetown DS350
- Q&A: Troubleshooting Brake Lines Under Timbren Rear Suspension Enhancement On 2013 Ford F53 Motorhome
- Q&A: Dimensional Drawing of the Timbren Rear Suspension System # TFRF53A
- Article: Determining Trailer Tongue Weight