Why Would Running Lights of Trailer Being On Causing Both Blinkers to Flash
Question:
When I have the running lights on and use my turn signals both sides flash 2001 chevy Silverado 1500 4×4
asked by: Terry M
0
Expert Reply:
You have a short between the running light circuit and the turn signals on your trailer. You are going to have to go over the wiring of the trailer and see if you can find any cut or exposed wire between those two circuits and insulate the circuits as needed with electrical tape.
I attached a help article on troubleshooting trailer wiring for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed For Flat Towing a 2024 Ford Maverick Behind a 2010 Winnebago Journey With Air Brakes
- Q&A: Caliper Bolts for AL-KO/Hayes Disc Brake Caliper BP18-050
- Q&A: Replacement Oil Seal for AL-KO 568303
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Q&A: Which Instructions Are Used Installing a Roadmaster Brake-Lite Relay in a Ford F-150 w/ Neutral Tow
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Diode for Charging Line From Motorhome to Towed Vehicle (Toad)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Maintenance Schedule
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Article: Trailer Tire Sizing
- Article: Flat Towing Package for 2014-2015 Chevrolet Equinox