How to Determine if Pro Series Jack Could Fit Snap Ring Mount on Trailer
Question:
can i replace it by just removing the snap ring and replacing it with yours. are all snap ring hole sizes the same?what is the hole size on the psej10000101
asked by: Roger M
Helpful Expert Reply:
Not all of the snap ring install brackets between trailer jacks are the same size. On the Pro Series Trailer Jack, # PSEJ10000101, the outside diameter of the snap ring is 2-1/2 inches, which is also the diameter of the circular opening that attaches the jack to the mount. The inside diameter of the snap ring is 2.28 inches. If you happen to have a snap ring with same dimensions this would work well for you.
Product Page this Question was Asked From
Pro Series Snap-Ring Swivel Marine Jack - Bolt On - Sidewind - 10" Lift - 1,000 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 0 - 1000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Pro Series
more information >
Continue Researching
- Q&A: Recommended Spare Tire for a Ironton Trailer
- Q&A: Brake Assembly Recommendation for 2005 Wells Cargo Cycle Wagon Trailer with Dexter 3500 lb Axle
- Article: Replacement Automotive Lighting
- Q&A: Appropriate Wire Gauge For Trailer Wiring
- Q&A: Correct B&W Turnoverball Underbed Gooseneck Trailer Hitch for 2019 Ram 2500 Without Prep
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Common Torque Specifications for Lug Nut Size
- Q&A: Can 4.80-12 Tires Be Upgraded to 5.30-12 Tires
- Q&A: Replacement Tire Options For a 165SR13 Trailer Tire
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Jacks
- Article: Most Popular Wheel Bearings