Installation of Rear View Safety Backup Camera with Quick Connect Kit
Question:
these instructions are terrible and there is no wiring diagram. Yes I have installed a lot of systems over the years and I am mechanically inclined. With that said my camera system is the one that has the quick disconnect for towing. It is the one camera system but has connections for 3 cameras. On the wiring harness that goes under your dash which wire do I use, the V1, V2 or V3? I hooked the V1 to the power wire since I want my camera on all the time but I have not powered it up yet cause I want to make sure it is wired correctly. Thanks
asked by: Michael
Expert Reply:
I got some clarification on the installation instructions of the # RVS-770613-213 from my contact over at Rear View Safety and you will have the white (V1) and brown (V2) wires not connected at all. You will want to connect the red wire to your power source- either the reverse circuit or the 12v power and the black wire will be your ground. You will then connect the blue wire (V3) to the camera source.
I've also written up a quick guide for you here:
V1 (white)- Input 1
V2 (brown)- Input 2
V3 (blue)- Input 3
red- power source
black- ground
Product Page this Question was Asked From
Rear View Safety Backup Camera System with Trailer Tow Quick Connect Kit
- Backup Camera
- Backup Camera Systems
- Hardwired
- 130 Degrees
- Dash Monitor
- 7 Inch Display
- Rear View Safety
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Rear View Safety Backup Camera System with Trailer Tow Quick Connect Kit
- Shop: Rear View Safety Backup Camera System with Trailer Tow Quick Connect Kit - 2 Cameras
- Video: Rear View Safety Inc Backup Cameras and Alarms - Trailer Camera Systems - RVS-770613-213 Review
- Video: Rear View Safety Inc Backup Cameras and Alarms - Trailer Camera Systems - RVS-770614-213 Review
- Q&A: Best Trailer and Truck Backup Camera Combo On My 2006 Ford F-250
- Shop: Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors - 30" Lift - 6,000 lbs
- Shop: Rear View Safety Backup Camera System - 4 Camera Setup - Quad View Monitor
- Shop: Tire Grip Vehicle Traction Recovery Track for Snow, Mud, and Sand - Qty 1
- Shop: Rear View Safety Backup Camera System
- Search Results: trailer camera
- Q&A: How to Select Trailer Tires with Correct Load Range Rating for Trailer Gross Weight
- Shop: Ark Drop Down Corner RV Stabilizer Jacks - 24" Long Corner Steadies - Silver - Qty 2
- Shop: Tire Chains
- Video: Project Pro Slip-On Shoe Ice Cleats Review
- Article: Cargo Tie-Down Methods
- Article: How to Install E-Track in 3 Easy Steps
- Search Results: rvs camera
- Search Results: camera cable
- Search Results: rvs~501n~3
- Shop: Trailer Hitch
- Shop: Vehicle Tow Bar Brake System
- Shop: Brake Controller
- Video: Rear View Safety Inc Backup Cameras and Alarms RVS-501N Review
- Q&A: Recommended Backup Camera System for All Aluminum Enclosed Trailer
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Wiring Diagrams
- Search Results: rear view safety
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Replacement Lug Stud for Dico Trailer Hub Assembly 45263