Dimensions of the 6 and 7-Way Trailer Connector Mounting Box
Question:
Can you provide a drawing or product dimensions?
asked by: Jhar I
0
Expert Reply:
The 6 and 7-Way Trailer Connector Mounting Box, part number 18156, is 5-1/4 inches long X by 4-3/8 inches high 2-3/4 inches wide and has a 2 inch diameter hole for mounting the 6 or 7-way connector. There is a cutout in the rear of the unit for the wiring to pass through when it is mounted. Includes screws for mounting the connector and a steel hose clamp to secure the mounting box to the hitch.
You can see this box being measured in the attached video.
expert reply by:
Robert G
0
Product Page this Question was Asked From
6 and 7-Way Trailer Connector Mounting Box for Round or Square Tube Hitches
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 6 Round
- 7 Round
- Draw-Tite
more information >
Continue Researching
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: How to Replace or Install an RV Roof Vent
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Best 2024 Honda Passport Trailer Hitch and Wiring Setup
- Q&A: Recommended Hitch for a 2024 Honda Passport
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Hub & Drum For UFP HD-1377-10 & Hydraulic Brakes For Boat Trailer
- Q&A: 7-Way Wiring Harness And Trailer Brake Controller For A 2024 Honda Pilot Trailsport
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Storage Latch For The Furrion RV Refrigerator # FCR14ACBQASS
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop