Which Advent RV Air Conditioner Most Easily Replaces a Coleman Mach Unit

Question

Question:

Hello, I have a Coleman pop up with a mach ac unit. Will this adapt right to my inside unit? My unit is a 833-871 cross ref to 48203C966

asked by: Spencer M

0

Expert Reply:

We have a version of the Advent Air RV AC unit that was designed specifically for replacing Coleman RV AC units with the part # ACCOL135 which installs easily since it uses same wiring connections and allows you to use your current thermostat.

expert reply by: Jameson C

0

Answer 1

The Advent Air RV Air Conditioner w/ Air Distribution Box and Wall Thermostat, #ADV94FR that you linked to is a complete 13,500 Btu unit that can be used as a new installation or replacement for existing unit. If your current Coleman Mach AC Unit has…

view full answer...

Answer 2

The Advent Air RV Air Conditioner w/ Air Distribution Box and Wall Thermostat - 13,500 Btu - White #ADV94FR will replace your Coleman Mach. You can use the same wire set up in your wall, you can just splice the new wires from the AC unit into your…

view full answer...

Answer 3

It sounds like you might be looking to add a heat strip to the Advent Air RV Air Conditioner part #ADV94FR and in which case you will simply need the Electric Heat Strip for Advent Air RV Air Conditioners part #ACMHD.

view full answer...

Answer 4

It sounds like you're looking for a replacement for your Coleman Mach AC unit. Since you have a Coleman setup I recommend the Advent Air Replacement RV Air Conditioner for Coleman Setup w/ Start Capacitor - 13,500 Btu - White #ACCOL135. This AC…

view full answer...

Answer 5

The only difference between the Advent Air RV Air Conditioners #ACM150 and #ACDOM150 is that the latter comes with the Start Capacitor for Advent Air RV Air Conditioners #ACMSCKIT. If you wanted to you could buy the Advent Air RV Air Conditioners…

view full answer...

Answer 6

The Advent Air RV Air Conditioner w/ Air Distribution Box and Start Capacitor part #ACM135C is designed for roofs 14-1/4" x 14-1/4" ranging from 2-1/2" to 5" thick. If the roof thickness does not meet this minimum requirement you…

view full answer...

Answer 7

To bench test the Motor #LC183058 on your Lippert Electric Tread Lite Step #LC353620 you can simply connect the motor wires a 12 volt battery source to operate the motor. The motor is reverse polarity so you can run it in and out by alternating the…

view full answer...

Answer 8

It could be an issue with the motor. If you can hear it running but nothing is moving, the best thing to do is to start by bench testing the motor. You can hook up to 12v and ground and the motor should run and turn. If you can hear it run but…

view full answer...

Answer 9

Thats definitely a gear box issue. Do you know which specific RV steps you have on your RV?

view full answer...

Answer 10

There is not a standard plug available that would allow you to plug the Advent Air Rooftop RV Air Conditioner #ACM135 right to an extension cord. The unit will need to be hardwired using the included wiring and hardware. I have attached the complete…

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Which Advent RV Air Conditioner Most Easily Replaces a Coleman Mach Unit

Product Page this Question was Asked From

Continue Researching