Can Thule TracOne Ladder Rack Be Bolted To a Trailer

Question

Question:

Can the base support of each leg of the ladder rack be drilled and secured with proper bolts and locking nuts to an aluminum trailer to allow for carrying other kayaks? If the length of the base support is 16 inches, what is the width? Thank you.

asked by: Jesse

0

Expert Reply:

The base supports of the Thule TracRac # TH27000XTB measure 3-1/4 inches wide. Although the rack wasn't designed for this purpose, I don't see why it wouldn't work. You could indeed drill down through the base supports to attach it to the trailer.

expert reply by: Mike L

0

Answer 1

The TracRac TracONE Ladder Rack #TH27000XTB will fit your 2004 Ford F-250 with a 6-3/4 foot bed. However, there is very tight clearance between loads that extend over the truck's cab and the cab's roof. I've attached a picture of the same…

view full answer...

Answer 2

Just to clarify you do want just the length of the base support that holds the bars?

view full answer...

Answer 3

I checked with Thule and the only way the Thule TracRac TracONE ladder rack part #TH27000XTB can fit your 2014 Toyota Tundra Crewmax with the deck rail system is if you remove the deck rail system like you mentioned. If you are willing to do that…

view full answer...

Answer 4

The best practice is honestly to replace tires in pairs. That way they should wear at the same rate and they'll be on the same replacement rotation. This being said, if the tires on that axle were still pretty new (a year or less old) and…

view full answer...

Answer 5

If your right turn signal is blinking with the left turn signal applied that most likely means you have a short between the right turn and left turn signal circuits or you possibly have the left turn signal shorted out to the running light circuit as…

view full answer...

Answer 6

To measure the width of a trailer wheel you will measure from where the tire beads will seat on the wheel. That will be from the inside of the inner wheel flange to the inside of the outer wheel flange, not from edge to edge of the wheel. To measure…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

Hey Buddy, so the Fastway Adjustable Ball Mount part #DTSTBM6825-2S is a really great choice for the 2-1/2 inch hitch of your 2021 Ford F-250 which is going to be very solid in your hitch due to it's built in anti-rattle device that is easy to…

view full answer...

Answer 9

I recommend going with the Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs #AL89DQ for hauling around an in-bed camper with your 2024 Ford F-350 Super Duty. I really like this kit because it has the higher 7,500 lb rating (which you don't…

view full answer...

Answer 10

Yes, the B and W Companion Slider Hitch part #BWRVK3370 does fit the OEM prep kit of a 2021 Ford F-250 Super Duty. Newer trucks do sit up higher but so do the newer fifth wheel trailers to compensate for that so as long as the truck doesn't have…

view full answer...

Answer 11

I have a solution for you Travis as Pace Edwards does not offer a contractor rack for your 2023 GMC Sierra 1500. Instead you can use the Pace Edwards Full-Metal JackRabbit Retractable Hard Tonneau Cover #311-M-FMCA28A59 with the Thule TracRac SR…

view full answer...

Answer 12

Yes, the Thule TracRac SR Sliding Truck Bed Ladder Rack #TH57RV will fit your 2020 Ram 1500 with the 5'7" bed and no Ram box. Unfortunately, this rack is only available in the silver color. We do offer the TruXedo Elevate Truck Bed Rack…

view full answer...

Can Thule TracOne Ladder Rack Be Bolted To a Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching