Dimensions of the Surco Universal Exterior RV Ladder # SP502L
Question:
what is the distance from the vertical riser part of the ladder to the vertical descender where it connects into the roof. In other words how far in does it go before turning 90 degrees and going into the roof.
asked by: Steve P
Expert Reply:
The top hooks of the Surco Universal RV Ladder, # SP502L, that attach to the roof of an RV measure 10-1/2 inches from center to center and it measures approximately 7 inches from the vertical pole to the point on the hook just before the 90 degree bend.
This ladder has an overall length of 84-1/2 inches, 12 inches between the vertical bars and 13 inches between each step on center.
I have attached a photo showing the dimensions that I have listed for you.
Product Page this Question was Asked From
Surco Exterior RV Ladder - Aluminum - 84-1/2" - 250 lbs
- RV Ladders
- Exterior Ladders
- Aluminum
- 7 Feet Tall
- Silver
- Surco Products
more information >
Continue Researching
- Shop: Surco Exterior RV Ladder - Aluminum - 84-1/2" - 250 lbs
- Search Results: rv ladders
- Shop: Replacement Standoff for Surco Exterior RV Ladders - Qty 1
- Shop: Surco Exterior RV Ladder - Aluminum - 97" - 250 lbs
- Video: Pro Series Anti-Rattle Device Review
- Video: Stromberg Carlson Hitching Post Chain and 7-Way Plug Holder Review
- Video: Brophy U-Bolt Stabilizer Clamp Review
- Search Results: surco ladder
- Search Results: anti rattle clamp
- Search Results: butyl tape
- Search Results: rv ladder
- Q&A: Where to Apply Caulk When Installing Trailer Roof Vent
- Q&A: Replacement Exterior Ladder With Extension
- Q&A: Width of Surco RV Ladder
- Q&A: Availability of Exterior Rear Ladder To Fit a 1999 Georgia Boy Cruise Master
- Shop: Replacement Standoff Nut for Stromberg Carlson RV Exterior and Bunk Ladders - Qty 1
- Q&A: How to Determine Where to Install Universal RV Ladder
- Q&A: Distance Between Surco # SP502L Ladder and Wall
- Video: Review of Surco Products RV Ladders - Exterior Straight Ladder - SP502L
- Shop: Pro Series Anti-Rattle Device for 2" x 2" Trailer Hitch Receivers
- Shop: Kuat Magnetic Hitch Receiver Reducer Sleeve - 2-1/2" to 2" Hitch - 6-1/4" Long
- Shop: Brophy Stabilizer Clamp and U-Bolt for 2" Hitch Receiver - Black Powder Coated Steel
- Q&A: Rear RV Ladder for a 2004 National Dolphin Heritage Motor Home
- Search Results: fans
- Search Results: ladder
- Article: Trailer Wiring Diagrams
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Article: How to Measure for Trailer Hitch Drop
- Video: Stromberg Carlson RV Exterior Ladder with Hinges Installation - 2021 Keystone Passport SL Travel Tra
on RV Ladders
