Which Westin Bumper Brackets Fit 1996 Ford Bronco

Question

Question:

1996 Ford bronco full-size 5.8 motor with these brackets fit his bronco

asked by: George

0

Expert Reply:

The Westin bumper bracket kit part # 95600 does fit the 1996 Ford Bronco and is normally used to install a Westin Fey Surestep part # 21002-95600.

expert reply by: Jameson C

0

Answer 1

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 6

From what I could find out about your current circuit board, the Atwood Replacement Control Panel #AT91367 will be a direct replacement.

view full answer...

Answer 7

It sounds like you are asking if a Reese weight distribution system head will fit on a Draw Tite weight distribution shank which the answer to that is yes.

view full answer...

Answer 8

There's not many differences between the Air Lift WirelessONE item #AL25980EZ and item #AL25980. The main difference is that the item #AL25980EZ has a slightly higher CFM at 1.03 compared to 0.92 and it runs slightly more efficient at 9% over 15%…

view full answer...

Answer 9

For your application you need the Air Lift LoadLifter 5000 which has that 5,000 lb weight capacity you mentioned. Please note that suspension enhancement is designed to help the OEM suspension on your 2021 Ford F-250 and won't increase the weight…

view full answer...

Answer 10

The best air bag kit for your 2022 Ford F-350 that has a single rear wheel axle is the part #F95FV which has the 5,000 lb capacity you are wanting. Firestone bags are superior Air Lift bags. The ply rating of the rubber is higher, the attachment to…

view full answer...

Answer 11

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Which Westin Bumper Brackets Fit 1996 Ford Bronco

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching