Availability of Just Light of Tow-Rax Recessed LED Light # TWSPRLB2L

Question

Question:

Looking at TWSPRLB2L, just what Im looking for, however I already have recessed Halogen lights on my trailer. Therefore I dont need the housing. Do you have just the light assembly available? Thanks, Barry W

asked by: Barry W

0

Expert Reply:

For just the light without the housing you'd just need the part # TWPWLS110V50W.

expert reply by: Jameson C

0

Answer 1

For your application you need the Pre-Greased Easy Grease Trailer Hub and Drum Assembly #AKHD-655-35-EZ-K. This matches all of the specs you mentioned and while it's only rated for 3.5K axles, it will still work for your Lippert 4.4K axle since…

view full answer...

Answer 2

For your 2008 Chevy C4500 Kodiak we have front suspension enhancement like the Timbren part #TGMFTK as a confirmed fit which can provide you with 8,600 lbs of additional suspension support but there are no air bag kits that fit your vehicle. The…

view full answer...

Answer 3

Yes, the replacement light you'd want for the Tow Rax Recessed LED Fixture part #TWSPRLB2L that you referenced is the #TWPWLS110V50W.

view full answer...

Answer 4

The bucket dimensions for Tow-Rax Recessed LED Light #TWSPRLB2L are 9 3/4" x 9 3/4" and is 5 1/2" deep, so you will need a hole at least that big. If the hole is slightly larger it will still work, so long as the flange on the end has…

view full answer...

Answer 5

The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…

view full answer...

Answer 6

The Replacement LED for Tow-Rax Recessed Lights #TWPWLS110V50W that you referenced most likely would work fine on your trailer that has flood light buckets already installed in it. This is designed to fit internal bucket dimensions of 10-5/8"…

view full answer...

Answer 7

An individual LED type light may not put out as much light as certain individual halogen lights do, but because, as you noted, LEDs use so little power you can use more of them. You could potentially BOTH increase your overall light output and still…

view full answer...

Answer 8

As the Ultra Bright LED Flood Light part #3371492196 is a 75 watt LED light, the amperage draw when hooked to a 12V system will be 6.25 amps. This drops to 3 amps when wired to a 24V system. So it will depend on the voltage and amp hours the battery…

view full answer...

Answer 9

Both the MORryde Rubber Equalizers #MR87ZR and Dexter E-Z Flex Suspension Kit #K71-652-00 are achieving the same result. They are doing so with slightly different designs but end up with the same result. I recommend using the Dexter E-Z Flex…

view full answer...

Answer 10

The Exterior LED Utility Light part #M337FR has three wires, one for power, one for ground, and one for neutral. I spoke with M-3 and they informed me that the light follows EU Wiring Specifications so the power should be brown, the neutral should be…

view full answer...

Availability of Just Light of Tow-Rax Recessed LED Light # TWSPRLB2L

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching