Will MB Sturgis Sturgi-Stay Propane Fill Hose Work with 100 lb Bulk Propane Tank Valve?

Question

Question:

Will this work with a 100 lb cylinder bulk fill valve

asked by: Keith

0

Expert Reply:

Yes. The MB Sturgis Sturgi-Stay Propane Fill Hose - POL Pigtail x 1/4" Male Inverted Flare - 15" # 100019-15 will fit the 100 lb tank POL valve fitting.

expert reply by: Jason S

0

Answer 1

Both the MB Sturgis Propane Pigtail Hose #100019-15 and Propane Hose #37207-30605 will require a Adapter Fitting w/ Back Check #204120-MBS when going into a changeover regulator. Most Regulators #888001-MBS will come with these back check valves…

view full answer...

Answer 2

The vent on a regulator should always be facing down to allow gravity to properly vent the regulator. If your system has your pipes running horizontally then you would want the MB Sturgis Horizontal 2-Stage Propane Regulator - 11" Water…

view full answer...

Answer 3

From what you described it sounds like you're needing the T-Fitting #103602-MBS along with the Fill Hose #100019-144 (for your small tank), the Tank Connector #204037-MBS, and the 2-Stage Propane Regulator #108221. Attached is a photo of…

view full answer...

Answer 4

For you, I recommend using the MB Sturgis Sturgi-Stay T-Fitting w Hose #103615 which will allow you to add a 100lbs propane tank to your existing dual 20lbs tanks. The red type 1 ACME fitting will connect to one of your tanks, and the pigtail from…

view full answer...

Answer 5

The MB Sturgis Propane Pigtail - Stainless Overbraid - Type 1 x 1/4" Male Inverted Flare - 15" #100833-15 is an 1/4" inverted flare tip and your regulator requires a standard 1/4" NPT fitting. You just need a pigtail like Propane…

view full answer...

Answer 6

Looks like you are in need of the Propane Adapter Fitting - 1/4" Female Inverted Flare x 1/4" Male NPT #37207-30045 to replace the fitting you have currently in your regulator.

view full answer...

Answer 7

The difference between the prices of the JR Products Automatic Changeover LP Gas Regulators and Camco Automatic Changeover 2-Stage Propane Regulators are in the BTU per hour, which as you correctly noted, is important information. The JR Products…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 10

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 12

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Will MB Sturgis Sturgi-Stay Propane Fill Hose Work with 100 lb Bulk Propane Tank Valve?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching