How To Determine Fit of Paddle Handle Locking Latch w/ Release PLR5115
Question:
I need to replace the latch for my WW 92 horse trailer. The outside dimensions match, 5 1/2 by 4 1/4 and it looks exactly the same. But my inside dimensions are coming out to 3 by 4 3/8. Will this latch fit at all or do you have one with these specs?
asked by: Jesus A
0
Expert Reply:
The Paddle Handle Locking Latch w/ Release part # PLR5115 is designed for a cutout which measures 4-5/8" x 3-3/8". Therefore, you'd need to enlarge the cutout but the latch would still work just fine. I don't have any other options that match the exact dimensions you provided so enlarging will be your only option.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Locking Paddle Handle w/ Internal Release - 5-1/2" Long x 4-1/4" Tall - Zinc Plated Steel
- Trailer Door Latch
- Latches
- Flush Latch
- Steel
- Built In Lock
- 3-3/8 x 4-5/8 Inch Cutout
- Polar Hardware
more information >
Continue Researching
- Shop: Full Size Locking Steel Flush Door Latch
- Q&A: How to Wire Solera Smart Arm 12V Power RV Awning
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: How to Determine the Length of Cable to Use on an Enclosed Trailer Ramp Door
- Q&A: Availability Of Adapter To Go From 1-1/4" Hitch To A 2" Hitch
- Q&A: Availability of Brake Line Fitting to go from 1/8 inch Male NPT to 3/16 Female FIF
- Article: Trailer Wiring Diagrams
- Q&A: Can the T-Handle Door Latch Assemblies # L4080 Be Ordered Keyed-Alike?
- Q&A: How Deep is the Latch and What Size Door Will T-Handle Locking Stainless Steel Flush Door Latch Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: What Exactly is Tongue Weight?
- Article: Roadmaster Vehicle Specific Base Plates