Trailer Taillight Kit for Tracker Boat Trailer

Question

Question:

Looking for a complete new harness and all led lights for my tracker trailer. Any idea what parts fit? It is a 2006. Type PT190. Thank you

asked by: Brian

0

Expert Reply:

I wasn't able to find a decent picture of the boat trailer you have so it's hard to say for certain what would be an exact replacement. We do have kits that work great on boat trailers like yours with the part # TLL16RK which we've installed on similar boat trailers that would be an excellent option. I attached an install video for this kit on a smaller boat trailer for you to check out as well.

expert reply by: Jameson C

0

Answer 1

For that we have the Waterproof, Over 80" LED Trailer Light Kit with 25' Wiring Harness #TLL16RK which comes with all new wiring, taillight assemblies, and a license plate bracket.

view full answer...

Answer 2

The maximum for disc brakes and the Carlisle actuator #HBA16 is 1600 psi. If you are looking for a drum brake actuator then use #T4813102 and add the reducer #T4844100. Drum brakes require less pressure, 1000 psi maximum. The Titan actuator reaches…

view full answer...

Answer 3

It is possible to upgrade the leaf springs on a trailer to a higher rated set but I do not recommend this as it can create a rough ride. The better option would be to install the SumoSprings Trailer Helper Springs part #TSS-107-40 for overslung or…

view full answer...

Answer 4

Leaf springs typically have the part #stamped on the strap that holds the leafs together at one end of the shorter leafs, or it is painted on the concave side of the springs. The part number can then be used to determine the capacity of the springs.…

view full answer...

Answer 5

If you are wanting to go to higher capacity leaf springs I would advise against it. The problem is that since the trailer axle is rated for 3,500 pounds you won't gain any additional capacity by switching to higher capacity springs. What it will…

view full answer...

Answer 6

A trailer light that only has 1 wire means that it grounds through its mounting hardware. The single wire is the power wire. The best surface to ground a light to is steel. If steel is not available in the area the light installs you can attach a…

view full answer...

Answer 7

The Bulldog Collar-Lok coupler #BD028243 is designed to fit around a 3 inch wide tongue so it is slightly larger than 3 inches on the inside. Since you have a 3 inch wide tongue this coupler will fit. I have included a link to a video review for you.…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Trailer Taillight Kit for Tracker Boat Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching