Differences Between etrailer e98852 and Draw-Tite 75662 Class III Hitches for 2019 Ram 1500 Classic
Question:
I am looking for a Class III hitch for our 2019 Ram Classic 1500. What is the difference between your stock #e98852 and #75662?
asked by: Richard P
Expert Reply:
The etrailer brand # e98852 and the Draw-Tite # 75662 are almost identical. The capacities are the same, they'd both install in the same manner and they're very similarly priced. There are a few differences. The biggest difference is that the etrailer # e98852 hitch itself is manufactured in the USA, while the the Draw-Tite model is manufactured in Mexico. Other more minor differences- the etrailer hitch uses a matte powder coat finish, while the Draw-Tite coating is a bit more glossy. The etrailer hitch upper mounting holes are slotted for an easier fit, while the ones on the Draw-Tite are round.
If I had to choose between the two, I'd go for the etrailer model because it's domestically manufactured. I've linked to some installation videos that you might find helpful.
Products Referenced in This Question
etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- No Cross Tube
- etrailer
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- No Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Troubleshooting the Fogatti RV Tankless Water Heater with E1 Code
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Does AirLift # AL57399 Air Bags Fit a 2019 Ford F-350 with Dual Rear Wheels
- Q&A: Center to Center Eye Measurement of B355 Roadmaster Endlinks Included in Kit RM-590170-00
- Q&A: What Air Bag System Should I Use on my 2020 Ford F-250 with Factory Prep Package?
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Trailer Hitch Recommendation for 2017 Ram 1500
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Determining Trailer Tongue Weight
- Article: Which Hitches are Made in the USA
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
Nick
7/26/2020
My truck is a 2019 ram 1500 classic tradesmen with a in bumper ball mount. Will the Draw tight adapter work on it? The rear mounting holes look farther apart then the ones in the video and on the mount. What is the measurements from center to center on the rear mount holes?