Trailer Wiring Harness Recommendation for a 2010 Chrysler Town and Country
Question:
can i use the Tow Ready Vehicle Wiring harness #119146 on my 2010 town and country, need a replacement for Curt powered converter have all wiring in place just need the converter dealer said curt unit was burned out only after a 1 1/2 years of use of maybe 5 towings of 2 trailers, need the the least expensive replacement, am very apt at wiring, will probably reuse connectors of the old unit, have all the butt connectors to do a nice replacement
asked by: Ric
Expert Reply:
The correct harness for a 2010 Chrysler Town and Country is # 118552. This is the updated converter that is rated for 7.5 amps stop/turn lights per side and 7.5 amps total for running lights.
It is a powered converter that requires a direct connection to the vehicle battery but that should not be an issue if you already have one in place. This harness plugs in line with the vehicle tail light wiring so no splicing is required.
The hardwire harness would work in the same manner but it would be harder to connect. You would have to ground the red wire with the white wire (since on your vehicle the yellow and green wires from the converter will carry both turn and brake lights). But, it is rated lower than the 118552 harness (stop and turn lights are only rated for 2.1 amps max per side).
So basically the difference is that the correct harness comes with simple plug in style connectors and is rated for more amperage making it the best option for your van. I have included links to a video and the installation instructions for you.
Make sure to check the trailer wiring and grounds for possible shorts that may have led to the other converters failure.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Shop: Roof Rack
- Video: Best 2010 Chrysler Town And Country Trailer Hitch Options
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommendation For Hitch That Clears The Muffler On A 2010 Jeep Compass
- Q&A: Does Rear Bumper Panel of 2018 Dodge Durango Install After Draw Tite Hitch # DT38MR Installs
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Q&A: Recommended 7-Way To Hopkins Molded Trailer Wire with Different Colors
- Q&A: Trailer Hitch and Suspension Enhancement Recommendation for 2018 Dodge Grand Caravan
- Q&A: Best Trailer Hitch Receiver for Bumper Clearance on 2013 Chrysler Town and Country
- Article: Trailer Hitch Receiver Sizes
- Q&A: Trailer Axle Over-Under Kit to Lift Palomino Pop-Up Camper Trailer
- Article: How to Use a Roof Rack (Like a Boss)
- Q&A: Is Transmission Cooler Needed When Towing With 2015 Dodge Grand Caravan?