Can Dexter Over Under Kit Be Used To Lower Trailer and Will This Affect Tire Clearance
Question:
I want to lower the height of my rv trailer which is 12ft. 2in To fit in my shop which has a 12ft. door by moving the springs under the axles. Will this adversely affect tire clearance? How many in. will it the height?
asked by: Ron
Expert Reply:
The easiest way to lower a trailer with axles under the leaf springs is to flip the axle over the leaf springs via a over under kit, the Dexter Trailer Springs Over-Under Conversion Kit part # K71-384-00 for 2-3/8" diameter axles or part # K71-385-00 for 3" diameter axles. The amount of height decease will be equal to the diameter of the axle and height of leaf spring stack. In regards to tire clearance, this will decrease as well but only by about the amount of leaf spring stack. I would estimate a drop of 1-2" but so long as you have at least 3" from the top of the tire to the bottom of the fender once flipped you will be fine.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions for the MORryde ALLTREK 4000 Suspension Kit
- Q&A: Double Eye Leaf Springs For Tandem Axle Trailer With 10,500LB Rating and 24" Length on Spring
- Q&A: Does MORryde ALLTREK 4000 Cushioned Equalizer Sit Taller to Offset for Additiona Suspension Movement
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Q&A: What Leaf Spring Width SHould be Used with Dexter Over Under Kit # K71-384-00
- Q&A: Would Dexter 3,500 lb Axle Made in 1999 Use Same Hubs as Current