Pin Hole Size Of Draw-Tite Max-Frame Trailer Hitch 75547
Question:
What size pin hole does this have? a 1/2inch or 5/8?
asked by: Justin M
0
Expert Reply:
The pin hole of the Draw-Tite Max-Frame Trailer Hitch Receiver part # 75547 is 5/8 of an inch. The smaller hole is not used.
expert reply by:
Heather A
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: How to Bleed Brakes with Demco Hydraulic Brake Actuator
- Q&A: Maximum Towing Capacity for a 2011 Honda CRV
- Q&A: Class III Trailer Hitch Recommendation for 2009 Honda CRV EX-L
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: What Exactly is Tongue Weight?
- Q&A: Removing Rusted On Bolts for Trailer Hitch Installation
- Article: Trailer Lighting Requirements
- Q&A: What Size Bolts are Used to Install Draw-Tite # 75547 on a Honda CR-V
- Q&A: Install Instructions for Curt Trailer Hitch # C11555
- Article: How to Choose a Hitch-Mounted Bike Rack
- Q&A: Can Draw Tite Hitch for 2007 Honda CR-V Carry Motorcycle Carrier
- Article: Hitch Mounted Cargo Carrier Information