Bolt Hole Spacing of Curt C31022 Front Mount Receiver Hitch
Question:
I want to know how far between the centers on the bolt holes.
asked by: Tim
0
Expert Reply:
Side to side, all the attachment holes of the Curt # C31022 front mounted receiver are 30-3/8 inches apart. From the receiver end going rearward, the first two mounting holes on the flanges are 2 inches apart. The second and third hole are 6-3/4 inches apart. These measurements are all stated as center to center.
The front mount receiver fits 2002-2007 Jeep Liberty models. I've provided a photo showing the dimensions mentioned above, as well as a link to the installation instructions.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 350 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Where Will Curt C31022 Front Mounted Hitch Sit When Installed on 2005 Jeep Liberty
- Q&A: Does Installation of CURT Front Hitch # C31022 on 2003 Jeep Liberty Require Drilling
- Q&A: Is Install of B and W Hitch for 2019 Ram 3500 Different from 2500
- Q&A: Recommendation to Replace Jensen RV Stereo AWM975
- Q&A: Troubleshooting Jensen RV Stereo JWM60A That Will Not Turn On
- Q&A: Trailer Hitch Recommendation for a 2017 Toyota Corolla
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Q&A: Will Replacement Hand Sprayer for Dometic RV Toilet Work for SeaLand Traveler 910 Model Toilet
- Article: Rooftop Cargo Carriers
- Article: My Trailer Hitch Doesn't Fit
Stephen B.
9/8/2020
Obviously custom but, how does the bolt hole diagram compare to the curt 310220 for a 2010 Jeep Liberty? Do either have higher ground clearance?