Trailer Wiring Installation on a 2012 Hyundai Sonata
Question:
TO install wireing kit on my car it has a openig about 4in by 12in close to tail lights, can i use this to install t-connectors or all the felt lineing has to come out.
asked by: Clark B
Expert Reply:
If you can access the tail light wiring through the opening you are describing then you could perform the isntallation that way. However, you will still need to mount the converter box out of the way and pulling away the lining is the best way to get to the bare metal of the trunk area.
I have included a link to the installation instructions for you. I have also included a link to an FAQ article with tips on routing the power wire to the battery.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Hitch for a 2024 Toyota Grand Highlander
- Q&A: Trailer Hitch Receiver For a 2011 Hyundai Sonata For Carry Bikes With Hollywood Racks Sport Rider
- Article: Trailer Hitch Receiver Sizes
- Article: What Do I Need To Tow A Trailer?
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Recommended Trailer Hitch for 2013 Hyundai Sonata
- Q&A: How Can I Use My 2 Inch Bike Rack with my 1-1/4 Inch Hitch
- Q&A: Using 2 Inch Accessory with 1-1/4 Inch Trailer Hitch
- Q&A: Trailer Wiring Harness Recommendation for 2011 Hyundai Sonata
- Q&A: Operation Instructions for the Reese Elite Series Pop-In Ball Kit
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Tow Bar Wiring: Which Wiring Kit is for You?