Video to Use for Wiring a 7-Way to a Trailer
Question:
How do you wire the wiring harnes on the trailer
asked by: Bobby A
0
Expert Reply:
When wiring up 7-ways onto trailers we recommend highly that you use a junction box like the part # 38656 as it makes organizing and mounting the wiring much easier. If you check out the attached video you can see how we installed this junction box with a 7-way like part # H20046.
expert reply by:
Jameson C
0
Products Referenced in This Question
Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 6 - 10 Feet Long
- Plug and Lead
- 7 Round - Blade
- Hopkins
more information >
Product Page this Question was Asked From
Pollak Metal 7-Pole, RV-Style Trailer Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Do 8k Oil Bath End Caps On Lippert Axle Interchange With Dexter End Caps
- Q&A: Recommended Electric Over Hydraulic Brake Set Up for 2016 Montana 3710FL 5th Wheel
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Q&A: Is Adapter Needed to Install Dometic Water Heater # DMC74FR In Place of Atwood
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Printable Trailer Bolt Hole Pattern Template
- Q&A: Recommendation for Installation of a Brake Mounting Flange on a Trailer Spindle and Axle
- Q&A: Leaf Spring Recommendation for 4,400 lb Trailer Axle
- Q&A: Do I Need Brakes On Both Axles of a Car Hauler Trailer?
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Hitch Adapters and Extenders
- Article: Troubleshooting Brake Controller Installations