Does Draw-Tite Hitch 36652 for 2017 Buick Lacrosse Require Fascia Trimming or Removal
Question:
Does the draw Tite 36652 trailer hitch for the 2017 Buick LaCrosse require trimming the rear bumper fascia? If so, is it on the visible part of the bumper or hidden up underneath? Also, does installation require removal of the rear bumper or any other parts?
asked by: Ric
Expert Reply:
The Draw-Tite Receiver Hitch, part # 36652 for your 2017 Buick LaCrosse does require some fascia trimming, but the 5" x 6" area is located on the portion of the bumper fascia that's tucked on the underside of the vehicle, so it won't be visible.
As outlined in the attached installation instructions, you will need to temporarily remove the bumper fascia by first removing the license plate and taillights, so you can gain access to the last two fascia tabs that hold it in place.
Once the bumper fascia is removed, you'll also need to remove the bumper beam. To do this, you'll remove a nut and a bolt on each side, using a 15mm socket. Since the exhaust must be temporarily lowered for installation, I recommend using a strap, like # EM31350 to support it and avoid damaging it.
Products Referenced in This Question
Erickson Ratchet Tie-Down Strap w/ Web Clamp and S-Hooks - 1" x 15' - 500 lbs
- Ratchet Straps
- Trailer
- Truck Bed
- S-Hooks
- 1 Strap
- Manual
- 11 - 20 Feet Long
- 0 - 1 Inch Wide
- 351 - 500 lbs
- Erickson
more information >
Product Page this Question was Asked From
Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Slide Topper For 2021 Grand Design Reflection
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Bearing and Seal Kit for 2004 Kendon Motorcycle Trailer
- Q&A: Replacement Studs for RVD-H-865 7k Hub/Drum
- Q&A: 2" Trailer Hitch Receiver For Carrying A Cargo Carrier Behind a 2017 Honda HR-V
- Q&A: RV Slide Topper Awning For A 154 Inch Slide Out Box
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Solution for Replacing Dexter 8-222 Trailer Hubs and Bearings
- Q&A: Recommended Brake Controller For A 2017 Coachman Sportscoach 407FW Motorhome Freightliner XC Chassis