What is Diameter of Threaded Base Center Hole of Complete Propane Tank Holder # 37230BL

Question

Question:

I need the base to have a 1/2 in. diameter nut, to allow a 1/2 in. threaded rod.

asked by: Tom

0

Expert Reply:

The threaded hole diameter on the base of the Complete Propane Tank Holder # 37230BL that you referenced is 1/2 inch like you are looking for.

expert reply by: Jameson C

0

Answer 1

For your 20 lb tanks you want to use the kit #37220BL instead of part #37230BL that you referenced. The only difference between these kits is the length of the threaded rod that the hold down bar and wingnut attached to. The shorter one is used for…

view full answer...

Answer 2

We sure do! Starting with the base we have a mounting tray #37230BL that you can attach to the tongue of your trailer to secure two 30lb tanks. Next you'll need a regulator like part #888001-MBS, which also comes with a mounting bracket that…

view full answer...

Answer 3

As seen in the linked video, the #37207-30405 regulator bracket is indeed included with the #37230BL JR Products propane tank holder.

view full answer...

Answer 4

The Complete Propane Tank Holder Mounting Kit #37230BL uses a 1/2-13 Threaded Rod #37207-30525 for carrying two 30-lb tanks. You will need a taller threaded rod to hold your 40lbs tanks. I recommend using a Cover Diamond Plate Silver #290-2714 or…

view full answer...

Answer 5

It sounds like you already have the Bluetooth Remote Display for Go Power MPPT Solar Charge Controllers #GP37MR with the Go Power MPPT Solar Charge Controller #GP72RR. The Remote Display for Go Power MPPT #GP37MR actually uses a bluetooth app as…

view full answer...

Answer 6

Trailer manufacturers don't usually keep a good record of parts like these that they install at the factory, so the best way to determine the correct replacement bearings for your Jayco Eagle 10 is to simply pull a hub and check for the…

view full answer...

Answer 7

Since you're trying to do a decently large run you'd need to get two single stage regulators like JR Products High Pressure RV LP Gas Regulator #37207-30325 and connect them inline close to the tanks and then run them out to the Dual…

view full answer...

Answer 8

We have seen people mount storage boxes on either side of the nose of a V-nose trailer like what you see in the picture I attached. The part #DZ91717P would work well if you have room for it like that. The dimensions of the box are 36"…

view full answer...

Answer 9

The Treaded Rod #37207-30525 will allow you to switch the size of your propane tanks from 20lb to 30lb. The Complete Propane Tank Holder Mounting Kit #37230WH is for applications where you are adding dual tanks or replacing everything due to…

view full answer...

Answer 10

When it comes to replacing the tires and rims on your Jayco Eagle 8 Popup Camper The Kenda 5.70-8 Bias Trailer Tire with 8 inch White Wheel - 4 on 4 - Load Range C #AM30120 will work for you. The wheel/tire capacity is 910 pounds at 75 psi. It has…

view full answer...

Answer 11

I recommend to add Leveling Scissor Jack Set - 24" Lift - 10,000 lbs - QTY 2 #JSC-24 to the Rpod which will give you about 24" of height. When collapsed the jacks are 4" which is about 3/4" shorter than the other…

view full answer...

What is Diameter of Threaded Base Center Hole of Complete Propane Tank Holder # 37230BL

Product Page this Question was Asked From

Continue Researching