RoadActive Suspension Front Clamp Orientation for 2019 Ford F-150
Question:
This morning I installed the system on my F-150 4x4 super-crew, The issue I have the instructions do not say which hole you install the front cross bolt . We wanted to keep the threaded rod short so we installed cross bolt into the longest set up... After install was finished we noticed the rear hook end bracket is riding on the threaded rod not on the curved retainer.... Can you give any guidance as to the correct position of the cross bolt ??? Sincerely
asked by: Jeffrey L
Expert Reply:
I attached a picture that I got from RAS that shows how the front clamp is supposed to look of the # RAS3611-Y when installed on a Ford truck like your 2019 Ford F-150.
Product Page this Question was Asked From
RoadActive Suspension Custom Leaf Spring Enhancement Kit
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Leaf Springs
- Standard Duty
- RAS
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended RoadActive Suspension On 2014 Ford F-150 For Travel Trailer w/Weight Distribution
- Q&A: Best Way to Prevent Sagging Suspension When Towing a Trailer
- Q&A: Is RoadActive Suspension System Compatible Wtih 2021 Ford F-150 With Auto-Leveling Headlights
- Q&A: Which Roadactive Suspension Kit Fits 2023 Ford F-150
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Q&A: What RoadActive Spring Enhancements do You Recommend for a 6500 Pound Trailer on My 2021 Ford F-150?
- Q&A: How Much Does the Curt CrossWing for 5th Wheel Rails Weigh?
- Q&A: Recommended RAS for a 2020 Chevy Silverado 2500 Towing a 5th Wheel Trailer
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Determining Trailer Tongue Weight
Jeffrey Y.
1/20/2020
Looks like our finished install, our concern was with the other end... Which was bearing on the threaded adjustment rod. A call from another expert said not to worry about that as it would not cause any damage to the product...