Will the Roadmaster Bulb and Socket Kit # RM-155 Fit a 2012 Jeep Liberty

Question

Question:

Is there room for the addational socket/bulb?

asked by: Dan

0

Expert Reply:

I checked with Roadmaster and you can use the Bulb and Socket kit, # RM-155. This indicates that there is room in the tail light housing on your 2012 Jeep Liberty for the extra bulb. I have also a link to all of the flat towing FAQ articles we have for reference.

expert reply by: Michael H

0

Answer 1

The reason your brakes are locking up when you use the 7 Pole to 6 Pole Adapter, #47549, is because there are two ways that 6-way round trailer connectors can be wired, as you may have already discovered. The difference is the pin for the electric…

view full answer...

Answer 2

The 7-Way to 5-Way/4-Way Trailer Adapter #C35FR you found is for vehicles which have lamp out sensors and are towing a trailer or vehicle with led tail lights. Since your 2022 Jeep Cherokee Trailhawk should have a Charge Line #RM-156-25 I recommend…

view full answer...

Answer 3

On a 2006 Jeep Liberty installing a brake controller requires that it be hardwired to the vehicle. hardwiring is not vehicle specific so you can follow along with any video showing installation using a 4 and 7 way installation kit #ETBC7. I have…

view full answer...

Answer 4

The pin/function assignments for 6-pole and all other trailer wiring formats are shown in the help article that is linked for you. I also included a photo of 6-pole connectors detailing their common function assignments. In 6-pole connectors the 12V…

view full answer...

Answer 5

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 6

To see a couple diagrams that show how the 6-way to 7-way adapter part #47435 is wired up check out the pictures I attached. The 6-way of this adapter has the center pin as the 12 volt circuit. That is the usual circuit that gets moved around on…

view full answer...

Answer 7

When wiring a trailer connector, it is best to wire by function, as wire colors can vary. We have an excellent wiring diagram on our website, I will provide you a link so you can look at it. If you are looking at the inside of the trailer connector…

view full answer...

Answer 8

Did you mean to say that your motorhome was built on the F550 chassis? According to the literature I found online, that's the chassis that Newmar built the 2016 Baystar Sport 2903 on. If that's the case, you've likely missing the fuse…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 12

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Will the Roadmaster Bulb and Socket Kit # RM-155 Fit a 2012 Jeep Liberty

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching