Kwikee RV Replacement Step Motor For A 2003 Newmar Motor Home

Question

Question:

I have a 2003 newmar motor home and need to replace the step motor. This is what I have found for numbers on the motor.071201 12v 10328220 m015wm 205 1009. This was on the Kwikee label 0058317 151332. This is a 3 step unit. What motor do I need?

asked by: Kenneth H

0

Expert Reply:

I contacted Lippert on your behalf. If this is the original triple step motor that came with the motor home, the update kit/Replacement Motor with Table for Kwikee 25 Series Electric RV Steps # LC379804 is what they recommended.

Included is a video overview with additional information on this solution.

expert reply by: Patrick R

0

Answer 1

Replacement Motor with Gear and Table for Kwikee 24 and 25 Series Electric RV Steps #LC369529 is my recommendation to replace your gear assembly and motor. The Replacement Link Assembly for Kwikee 24 and 25 Series Electric RV Steps #LC369488 is the…

view full answer...

Answer 2

Typically you will want to use the Motor Upgrade Kit #LC29VR with the older steps to upgrade all the components. As long as you have the updated Control Unit #LC379146 on your steps you will only need the Gearbox #LC379160 and Motor #LC379147.

view full answer...

Answer 3

Since your Kwikee step setup shows that it's a Series 28 step the correct motor upgrade kit is the part #LC29VR that you referenced.

view full answer...

Answer 4

The 9551 motor for your Kwikee 23 series steps is no longer available for your 2001 Holiday Rambler. Given the year of your RV, the Motor Upgrade Kit for Kwikee Electric RV Steps #LC379145 would be the correct replacement option for your steps…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Since you need the Replacement Control Unit for Kwikee 38 Series Electric RV Steps #LC363989 I'm assuming you have 38 series steps on your 2017 Thor Windsport. The correct replacement motor for these steps would be the #LC379147.

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Thank you for the pictures- they're always helpful! I have a solution for you, but the Lippert gear box you were looking at is a replacement for the newer Kwikee 32 Series Steps. I spoke with my contact at Lippert and they said that the gearbox…

view full answer...

Answer 10

There are indeed many different replacement step controllers out there and I am happy to re-confirm that the correct current item to replace your Kwikee step controller 1800709 is part #LC363989. I verified this item with my parts contacts at…

view full answer...

Answer 11

Yes, I can indeed verify for you that the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C55451 does fit your 2005 Jeep Grand Cherokee without the factory tow package wiring.

view full answer...

Answer 12

If the Jeep does not have a tow package, I recommend Curt T-Connector part #C55451 because it can handle 1 more amp per circuit than the other trailer wiring options for your Jeep. The more amps per circuit the better especially if you are towing a…

view full answer...