Truck Cap Camper Shell Ladder Rack 2020 Ford F-250 Super Duty 8 Foot Bed

Question

Question:

Do you have a ladder rack to go on top of my ARE cap on my new 2020 F250 SD long bed? What kind of weight can I put on it?

asked by: Trenton

0

Expert Reply:

Thule does make a TracRac CapRac Ladder Rack for Camper Shell/Truck Cap, with part # TH29200XT. This will work well with the A.R.E truck cap on your 2020 Ford F-250 Super Duty with the long bed.

The bars are 65 inches long and the capacity is limited to the capacity of your A.R.E camper shell.

expert reply by: Carla M

0

Answer 1

The Thule TracRac CapRac Ladder Rack for Camper Shell/Truck Cap #TH29200XT is not actually meant to be installed into top tracks. This crossbar system is actually meant to be installed in fixed points on your camper shell so it's not going…

view full answer...

Answer 2

Yes Yakima roof racks can fit the Thule roof rack tracks. To do that you will need 4 of the Yakima Control Towers #Y8890027, 2 sets of the Yakima Landing Pad #Y00221, and one set of Yakima Crossbars. For 58 inch bars you can use #Y00409, for 66 in…

view full answer...

Answer 3

The Replacement FootBase for Thule Tracker #753-2149 is what you currently have on the Thule tracks on your Leer shell. This footbase is for the now discontinued Thule Tracker square bar setup. You may be able to piece this system together even…

view full answer...

Answer 4

For your A.R.E. Truck Cap that features the Yakima tracks, you will just need 4 of the Yakima Control Towers #Y8890027, 2 sets of the Yakima Landing Pad #Y00221, and one set of Yakima crossbars, which come in varying lengths. For 58 inch bars use…

view full answer...

Answer 5

The factory rails on your A.R.E. topper are made by Yakima. For a complete roof rack system on your 2012 Ford F-250 SD with the A.R.E. topper you will need the following parts: 4 of the Yakima Control Towers #Y8890027 2 sets (2ea) Yakima Landing Pad…

view full answer...

Answer 6

Yes, all other components for the TracRac CapRac Ladder Rack, #TH29200XT, can be removed while leaving the swivel brackets in place. I have included a snapshot of the installation guide to show how the rack corner attaches to the swivel bracket. All…

view full answer...

Answer 7

With the weight of your camper I recommend the Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL35FJ. I prefer these as they have the internal jounce bumper which helps to reduce the bounce that is often associated with towing a trailer and…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

The best air bag kit for your 2022 Ford F-350 that has a single rear wheel axle is the part #F95FV which has the 5,000 lb capacity you are wanting. Firestone bags are superior Air Lift bags. The ply rating of the rubber is higher, the attachment to…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Yes, you can replace your current Lippert Equa-Flex equalizers with the MORryde AllTrek 4000 Equalizers #MR29DR on your 2018 Highland Open Range. The yellow octagons on the front and rear are a for correcting the alignment of the axles and are not…

view full answer...

Answer 12

If you have the Ford 3" hitch then you can definitely add it but, yes it would change the weight capacity. The TorkLift Cannon Hitch Extension item #TLE1636 only has a 3,600 lbs towing capacity and a 360 lbs maximum tongue weight. If used with a…

view full answer...

Truck Cap Camper Shell Ladder Rack 2020 Ford F-250 Super Duty 8 Foot Bed

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching