How Long is the Mounting Bolt on the Optronics LED Clearance Light # MCL95AB
Question:
How long is the bolt on product code: MCL95AB? Are all stud mounts typically the same length? I have a 20 ft boat trailer which currently has stud mount amber running lights on the sides, I just want to make sure these would fit before ordering. Trailer is made by REME. Thanks for your help!
asked by: Ian K
Expert Reply:
The bolt on the back of the clearance light # MCL95AB is approximately 5/8 inches long from the back of the light housing to the end of the bolt. Not all bolts on lights equipped with them are the same length but they are generally within very close proximity, no more than 1/4 inch off, from the lights I have measured. The stud in this light is also the grounding point.
Similar lights, like # MCL13A2B, would mount using 2 screws with gasket # A13G2B. This light has 2 wires so you would need to ground the white one to the trailer frame.
Products Referenced in This Question
Foam Gasket for MCL13 Series LED Lights - Black
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Gaskets
- Optronics
more information >
Optronics LED Mini Clearance or Side Marker Trailer Light - Submersible - 2 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 2-1/2L x 1-1/16W Inch
- Amber
- Optronics
more information >
Product Page this Question was Asked From
Optronics LED Clearance or Side Marker Light - Submersible - 3 Diodes - Rectangle - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Stud Mount
- Submersible Lights
- LED Light
- 2L x 1W Inch
- Amber
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: How to Connect Trailer Safety Chain Hooks to Ford F-150 Factory Safety Chain Loops
- Q&A: Replacement Seal for Cool Hub on a 2000 Ranger Bass Boat Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement Bearings, Seals, Hubs For 2021 Riverside Retro 135 With 3,500 lb Axle
- Q&A: Replacement Fenders Needed for a 13" Wheel on a Tracker Trailstar Boat Trailer
- Q&A: Prep-Work for Installing Small Coin Pattern Vinyl Flooring with Adhesive
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Q&A: Torque Settings For Wheel Lug Nuts For Boat Trailer And utility Trailer