Solution for Attempting to Install Fulton XLT Winch on Trailer Where Mounting Plate Doesnt Match Up
Question:
I bought the Fulton winch XLT and it doesn't fit on my Road King Trailer plate. The holes on the product did not fall or fit in place with the plate already on the trailer. When I put the two bolts on the back dont line up exactly correct, they bolts are on an angle that if I screw them, they will bend or brake. it looks like the bolt's holes or the plate on the Fulton F2 are not wide enough to fit and fall in place on the holes that are already on my road king trailer. Please any advice. I like the product but before I start to look into drilling into my road king trailers plate, I would like to see if I am doing something wrong with the alignment or if there is any other option without spending more money. Please any advice will be greatly appreciated.
asked by: Jose R
Expert Reply:
The Fulton XLT Winch part # F142425 was designed to fit most winch mounting plates but it sounds like yours has holes that are just not totally compatible. Best option would be to drill new holes on your plate to allow the winch to fit without having any of the bolt holes angled. You'll want to drill new holes far enough away from the old holes so that there isn't any mounting plate strength compromised.
Product Page this Question was Asked From
Fulton XLT 2-Speed Trailer Winch - 10" Long Handle - 20' Strap - Zinc - 3,200 lbs
- Trailer Winch
- Standard Hand Winch
- Boat Trailer Winch
- Utility Winch
- Extra Heavy Duty
- Standard Hand Crank
- Two Speed Winch
- Polyester Strap
- Fulton
more information >
Continue Researching
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: Hand Winches
- Article: Trailer Tire Sizing
- Q&A: Replacement Winch Recommendation for Trailer with 4,000 lb Boat
- Article: Cargo Tie-Down Methods
- Article: Trailer Wiring Diagrams
- Q&A: What are the Dimensions of the Dutton-Lainson Covered Hand Winch DL17027
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Q&A: Replacemnet Surge Brake Actuator For a Tie Down Engineering LP7000
- Q&A: What Diameter Holes are Required For The LED Trailer Mini Clearance Lights MCL10AKB & MCL11RKB?
- Q&A: How To Install the Spindle Nut on a 12,000 Pound Dexter Axle
- Q&A: Will the Fulton Plastic Fender # F008573 Fit a 2000 Sea Ray 180 BR Trailer
- Q&A: Replacement Fenders for 2003 ShoreLand'r Tandem Axle Boat Trailer
- Article: Most Popular Wheel Bearings