Replacement Shoe for Fishers Snow Plow

Question

Question:

Looking for a replacement shoe for an xv2 Fisher plow

asked by: Richard A

0

Expert Reply:

The Replacement Anti-Wear Shoe Assembly part # 3371303300 for 6" or part # 3371303305 for 7" should fit the Fishers XV2 Snow Plow. However, you will need to confirm this by making sure the post diameter of 1.32" will work for you. I have attached a photo for you with some other measurements to assist as well.

expert reply by: Conner L

0

click to enlarge

Answer 1

The outer diameter of the shaft of the Replacement Anti-Wear Shoe Assembly for Fisher Snowplow #3371303305 that you referenced is 1.35 inches.

view full answer...

Answer 2

The diameter of the shaft on the Replacement Shoe Assembly #3371303003 is 1-1/4 inches and the length is 8-3/4 inches.

view full answer...

Answer 3

I went out to the warehouse and pulled the Cipa Universal Door Mount Mirror #CM45000 you referenced in your question. The measurement between the two bottom mounting holes on center is just about 10-1/2 inches. Vertically, from the bottom hole to…

view full answer...

Answer 4

The factory transmission cooler in most vehicles is integrated into the radiator. What this does is actually warm the cooler to the temperature of the radiator. A supplemental cooler does not touch the radiator so it will actually stay cooler than…

view full answer...

Answer 5

We do have a shoe for a Meyer snowplow with a 3/4" diameter shaft, the Replacement Shoe Assembly for Meyer Snowplow - Standard (Drive Pro) #3371303002. I have added a link to a video review with dimensions of this part for you to check out as…

view full answer...

Answer 6

The width between the springs is 1-1/2 inches for the Replacement Double Torsion Spring for Diamond Snow Plow - 4-3/4" Wide x 8-1/2" Long #3371302160. There is no weight specification for this spring at a 90 degree deflection.

view full answer...

Answer 7

I spoke with my contact at Curt and was able to get an installed picture of front mount hitch #31514. I have included it for you. Also, according to Curt the hitch measures just under 12 inches from the ground up to the center of the hitch pin hole.…

view full answer...

Answer 8

The replacement pin and cable you need for your Bright Way breakaway switch part #3802348 is the part #3802350!

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Replacement Shoe for Fishers Snow Plow

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching