MaxxAir Vent Fan LED Indicator Lamp on Control Board Flashing and Fan Not Working

Question

Question:

My fan has been working great up until today. I recently hooked up a 12 volt RV fridge directly to my deep cycle battery, my fan is connected to a controller as I have solar. All was working great for about 2 hours. I turned my vent fan to exhaust because it has cooled down and it started beeping, then stopped working altogether. The green auto light was flashing. It is on steady and nothing works. Ive tried pressing all the buttons... nothing. All hookups are good.

asked by: Lori

0

Expert Reply:

The logic board used in the fan will lock itself out to prevent damage if a voltage spike occurs. You can reset the board by disconnecting power to the fan for a few seconds and then reconnect. This will reset the board, and the fan should work properly after that. You'll want to make sure the fan is getting not much more than 12 volts, or this will continue to occur.

expert reply by: Mike L

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 9

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 11

For the front legs of a Lippert Ground Control 3.0 kit the replacement front jack leg solution you'd need is the part #LC362485. This will allow you to reuse your current motor and bracket. There isn't a gear replacement kit for the jack…

view full answer...

Answer 12

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

MaxxAir Vent Fan LED Indicator Lamp on Control Board Flashing and Fan Not Working

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching