Solution for Collar Lok Style Coupler with Broken Latch Mechanism

Question

Question:

Can this be repaired? Can I get just the peice that swings out and drive a new hinge pin in?

asked by: David P

0

Expert Reply:

Just the piece you broke on your Hammblow coupler is not replaceable. Only solution would be a new coupler like the Bulldog Collar Lok part # BD028463 that you referenced. Most likely your coupler is fatigued elsewhere too based on it breaking like yours did.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Your 5,200 lb Torflex axle is a #11. The correct mounting kit is the Dexter Torflex #11 Axle Side-Mount Frame Installation Hardware Kit #DX57FR.

view full answer...

Answer 2

I went out to our warehouse to get the following dimensions for the Dexter Torflex #11 Axle Side-Mount Frame Installation Hardware Kit #DX57FR as we do not have a dimensional drawing from Dexter. The overall length is 11-7/16", height of side…

view full answer...

Answer 3

Yes, you can drill holes into the Bulldog Collar-Lok Coupler w/ Low-Profile Latch #BD028288 to install it using the existing mounting hole configuration on your trailer.

view full answer...

Answer 4

Yes, you can replace your weld-on coupler with a bolt-on coupler you will just have to drill the holes The Demco Cast Head Coupler w/ Jack Hole #DM37ZR would be a good replacement. The coupler has a 10,000 pound weight capacity and will fit a 2 inch…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 7

Typical spring deflection for trailer leaf springs like the part #e64SR is right at 1-1/2 inches when at capacity. Generally speaking you will want to have 3 inches from the top of your tire to a fender on a trailer (in your case a deck) to…

view full answer...

Answer 8

It sounds like there is a short circuit that is overloading the running light circuit in the tow package wiring on your tow vehicle. The most likely culprit is a dirty or corroded trailer connector on the vehicle or trailer if not both. The first…

view full answer...

Answer 9

I don't think you are doing anything wrong necessarily. There are 2 possible issues that I can think of causing the problem. First, the spring may not be the correct size. A spring that is too short and/or not the correct diameter would fall out.…

view full answer...

Solution for Collar Lok Style Coupler with Broken Latch Mechanism

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching