How To Turn On Heat of 12-Volt Heater and Defroster # PTW5009

Question

Question:

But still wont let u use heat and fan same time

asked by: Tina

0

Expert Reply:

There's a rocker switch on the side of the 12-Volt Heater and Defroster # PTW5009 that you referenced that allows you to pick heat or fan. If you rock the switch towards the word "heat" it will put out heat and defrost your windshield.

expert reply by: Jameson C

0

click to enlarge

Tina

10/29/2019

But still wont let u use heat and fan same time

Reply

Jameson C.

10/29/2019

The fan of the # PTW5009 is designed to run in the heat and fan position. In both settings the same fan speed should be running. If your fan isn't running in the heat mode that would indicate it has a problem.

Reply

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Heater #PTW5009 draws 13 amps at 12 volts which equals out to about 156 watts. I did a little research and from what I could find it is not ceramic.

view full answer...

Answer 3

Yes, you are going to also need the Demco Autoslide Capture Plates for Trailair Rota-Flex Pin Boxes #DM6171 when using the Demco Autoslide 5th Wheel Trailer Hitch w/ Slider #DM8550040 with your Road Armor pin box. For a suspension enhancement I…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

Yes, the Curt Custom Fifth Wheel Installation Kit for Ford #C93WR will work just fine with the Demco Autoslide 5th Wheel Trailer Hitch w/ Slider #DM8550040.

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 9

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 10

Personally I feel like the Demco Autoslide 5th Wheel Trailer Hitch #DM8550040 is the best option for your 2021 Nissan Titan towing a 2011 Forest River Rockwood 8265WS. The Autoslide will move back up to 22-1/2" when you turn to give you the…

view full answer...

Answer 11

We do indeed offer a 5th wheel bracket/rail kit for the 2022 Ford F-150, the Curt #C93WR. If you'd like to install a 7-way trailer connector in the truck be, you can install one using part #C56000.

view full answer...

Answer 12

Both of the kits you mentioned are a fit for your 2016 Ford F-150. The difference is that the part #TFR1504E has a 6,000 lb capacity and the part #TFRTT1504E has a 7,000 lb capacity. You would want to go with the lower rated spring as it will be a…

view full answer...

How To Turn On Heat of 12-Volt Heater and Defroster # PTW5009

Product Page this Question was Asked From

Continue Researching