Could T-Bolts of Thule Dockglide Kayak Carrier Fit into Top Channel of 2018 BMW X1 Crossbars

Question

Question:

Will the T-bolts in the Thule Dockglide fit the channel in the current BMW factory crossbars? Or do you have to use the adapters?

asked by: Greg

0

Expert Reply:

Most likely the T-bolts of the Thule Dock Glide part # TH896 would fit the top channel on the crossbars of your 2018 BMW X1 but you'd need to measure to be sure. The T-bolt measure 3/4 inch by 3/4 inch and has a shank that is .23 inches thick. We've found that nearly all crossbar top channels have dimensions that work with this so I would be surprised if this did not fit.

expert reply by: Jameson C

0

Answer 1

For a kayak carrier that will mount directly on the crossbar T-tracks of your Triton trailer, I recommend the Rhino-Rack Nautic 581 Rear Loading Kayak Carrier #RR581. That is assuming that the c-channels or t-tracks on your trailer's crossbars…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hi Alec, The Inno Kayak Roof Rack w/ Tie-Downs #INA452 needs a 28" minimum spread so that the saddles sit at the right spot for the kayak and support the weight properly. This is probably just a general guide from Inno though because the length…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 9

The correct Thule roof rack that fits your 2024 Jeep Grand Cherokee with flush rails is the Wingbar Evo roof rack part numbers #TH711220, #TH710601, #TH68FE. The Wingbar crossbars are the quietest and most aerodynamic so they'll work really great…

view full answer...

Could T-Bolts of Thule Dockglide Kayak Carrier Fit into Top Channel of 2018 BMW X1 Crossbars

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching