Replacement Handle Rod for Flip Down Stabilizer Jacks

Question

Question:

Hi all, I lose the handle for this type of telescoping stabilizer. Is there a way to purchase one separately? regards,

asked by: Patrick M

0

Expert Reply:

If you have the Stabilizer Jacks part # TJ01RT-HD then I can confirm the correct replacement handle which is the Replacement Handle Rod for etrailer and Ram Stabilizer Jacks part # SJ-100-HD. That said, the handles are pretty standard you should be good to go no matter which jacks you have just make note of the handle diameter which is 1/2".

expert reply by: Conner L

0

Answer 1

The Kenda K353 Bias Trailer Tire - 5.30-12 - Load Range C #AM10066 has a speed rating of 65 mph and like you mentioned a max load capacity of 1,045 lbs at 80 psi. However you should make sure that the combined maximum load rating is higher than the…

view full answer...

Answer 2

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Yes, you can! So long as our Kenda Loadstar 5.30-12 Bias Trailer Tire with 12" White Wheel item #AM30820 is the same size and bolt pattern as what's on your Ironton trailer it can be used not only as a spare but also on your trailer with the…

view full answer...

Answer 5

There many possible ways to mount a stabilizer jack such as the #TJ01RT-HD you looked at. Mounting them in the orientation shown the diagram would tend to work a bit better to stabilize the trailer against side to side movement, while having the…

view full answer...

Answer 6

It does; the valve stem is indeed included with the Karrier ST205/75R15 Radial Trailer Tire with 15" Aluminum Wheel - 5 on 4-1/2 - Load Range C #KE27JR.

view full answer...

Answer 7

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 8

The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…

view full answer...

Answer 9

The weld-on mounting bracket for the ARK #AR94FR Drop Down Corner RV Stabilizer Jacks measures 4-5/8 x 2-7/8 inches. The bracket has holes for the hardware that attaches the jack to the brackets. The holes are 2-7/8 inches apart on center. I've…

view full answer...

Answer 10

While we don't carry that exact part number we do have a replacement hub/drum that would work just as well with the part #AKHD-655-6-EZ-K. This is a 6k hub/drum that fits the spindles of the Timbren Axle Less Kit part #ASR1THDS03.

view full answer...

Replacement Handle Rod for Flip Down Stabilizer Jacks

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching