Diameter of Cable on 6-Way Molded Trailer Wire Connector
Question:
What is the outside diameter of the cable? I need to know this to check to see if it will fit through the existing hole in the frame of my trailer, or if I have to drill it out.
asked by: Dan
0
Expert Reply:
The outside diameter of the cable used on the # H20036 6-Way Molded Trailer Wire Connector is 1/2 of an inch.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Hopkins 6-Way Connector with Jacketed Cable - Trailer End - 8' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 6 - 10 Feet Long
- Plug and Lead
- 6 Round
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Pintle-Hitches
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Exact Center Steering Stabilizer Fit For 2020 Jeep Wrangler JL
- Q&A: Will The AM31990 Tire/Wheel Fit On The etrailer Hitch Mounted Spare Tire Carrier e98ZR
- Q&A: Are Equalizers & Front Hangers for 2" Wide Slipper Springs Available
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Stabilizer Jack for 2015 Dutchmen Voltage Epic V3005 Toy Hauler
- Q&A: What is Minimum Distance Require between Tandem Trailer Tires When Considering Increasing Tire Size
- Article: Brake Controller Installation: Starting from Scratch