Replacement Hook Side Strips for TruXedo 1113645 Tonneau Cover on Dodge Dakota with 6-1/2' Bed

Question

Question:

Hello, I am in need of the hook strips of the hook and loop for my truxedo cover on my dodge Dakota 6.5foot box. the only part number I found was on the rail 1113645 it is an older one. soft top roll up with the vertical side rails. I can see the hook strips slide in a channel and have a couple rivets. I think it is 1 5/16inch which is the over all width of the track

asked by: Adam B

0

Expert Reply:

It sounds like you are needing the Replacement TruXedo Shur-Bond Velcro Brand Fastener for 6-1/2' Beds # TX1115174 which measures 1-5/16" wide like what you measured. This comes with 2 of the strips that mount on your rails as well as 3 rivets which would be used if you had the TruXedo Original Edge cover. Since the part 1113645 you mentioned indicates you have the Lo Pro you won't need to use the rivets for the installation.

expert reply by: Jon G

0

Answer 1

Yes the Replacement TruXedo Shur-Bond Velcro Brand Fastener for 6-1/2' Beds -1-5/16" Wide part #TX1115174 that you have looked at does have the elongated slots. When replacing it you will utilize these to get the strips in place and…

view full answer...

Answer 2

The TruXedo Side Rails 1113645 were used on a few different tonneau covers with the TruXedo Lo Pro QT Soft Roll-up Tonneau Cover being the most popular. Therefore, the Replacement Side Rail End Caps With Seals for Truxedo LoPro Tonneau Covers part…

view full answer...

Answer 3

I attached a diagram that shows how the DEKA Isolator part #DW08771 that you referenced needs to get wired to a vehicle with two batteries. Basically the center isolator post gets the alternator connection and then position 1 goes to the battery…

view full answer...

Answer 4

We have replacement tonneau cover Velcro that is exactly 1-5/16 inches wide with the Truxedo part #TX1115174 which would fit your rails. It can be cut down shorter too as it is 80 inches long.

view full answer...

Answer 5

The tarp #TX1117651 you're looking at is not going to fit your Titan, unfortunately. Instead, you'd need the Replacement Tarp for TruXedo Lo Pro Soft Tonneau Cover #TX588801-CVR.

view full answer...

Answer 6

The hook piece on a Velcro setup is usually the piece that fails first, especially in a setup like this where the hook piece is attached to the vehicle and would be out in the sun. As long as your truck bed is 6-1/2 feet long and the cover you have…

view full answer...

Answer 7

If you have the 8' bed then you can go with Replacement Truxedo Shur-Bond Velcro Brand Fastener for 8' Beds - 1" Width #TX1117877. If you have the 6-1/2' bed then you will want to go with Replacement TruXedo Shur-Bond…

view full answer...

Answer 8

There are 3 soft TruXedo Tonneau covers for the 2003 Dodge Ram short bed. If you have the TruXport, #TX246601 then the replacement cover only is #TX246601-CVR. If you have the Lo Pro QT #TX546601 then the replacement cover only is #TX546601-CVR. If…

view full answer...

Answer 9

Hey Ron, so the Replacement Retainer Straps and Clips for TruXedo TruXport Tonneau Covers #TX26FR are definitely not too difficult to install. This comes with install instructions to walk you through the entire process as well.

view full answer...

Answer 10

The best method to identify the tonneau cover on your 2008 GMC Sierra will be to look for the date code and or serial number. The serial number is located on the driver's side of the front header on the TruXport frame. The date code is printed on…

view full answer...

Answer 11

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel studs…

view full answer...

Replacement Hook Side Strips for TruXedo 1113645 Tonneau Cover on Dodge Dakota with 6-1/2' Bed

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching