Replacement Trailer Clearance Light for a Haulmark Trailer

Question

Question:

IS THIS THE CORRECT LIGHT FOR MY HAULMARK TRAILER

asked by: MARTY S

0

Expert Reply:

You will have to look at the original light to determine the manufacturer and model number. If it is listed on the light it will be on the light housing somewhere (not the lens). If it is not, then you have to go by the measurements of the light. This light measures 3/15/16 inches long, 1-1/4 inches tall, and 7/8 inches deep. It is an exact replacement for Peterson light M154A-R.

expert reply by: Michael H

0

Answer 1

We have the Dexstar Steel Spoke Trailer Wheel - 15" x 5" Rim - 5 on 4-1/2 - White Powder Coat, #AM20422. This is the Dexstar 5" 017-143-1X wheel. For a tire with a 2150 lb. load rating that fits this wheel, I suggest the Karrier…

view full answer...

Answer 2

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 3

I recommend the Buyers Products Ultra Bright LED Flood Light in either 4,050 Lumens #3371492190 or 9,000 Lumens #3371492196, to replace the halogen lights on your Haulmark Race Enclosed Trailer. You will want to verify the fitment for these as I am…

view full answer...

Answer 4

For your Glo-Brite 118A amber light the replacement lens that will fit is the Optronics #A44AB; the lights themselves are the Optronics #MC44AB. The Glo-Brite 117R can use replacement lens #A44RB while the light is #MC44RB. I've added links to…

view full answer...

Answer 5

You can certainly replace your existing incandescent marker/clearance lamps with LED models. LEDs have many advantages over incandescent lamps. They have a much longer life, they draw a fraction of the amperage and are brighter. The Optronics LED…

view full answer...

Answer 6

Based on your information, I recommend the Optronics LED Trailer Tail Light, Item #STL211RB. It has the stop, tail, turn, and backup options included. This Optronics light is 6-7/16 inches long x 2-5/16 inches wide. These dimensions are the same as…

view full answer...

Answer 7

I believe the Clearance Light part #MC65RB would be the correct light for you. The difference in length is about .1 of an inch which would be close enough. Especially since these look exactly like what you have and the other dimensions match up. The…

view full answer...

Answer 8

Thanks for submitting a picture of your vent! Because of that I can tell you need a #BV0554-01 which has a continuous hinge.

view full answer...

Answer 9

You have a short circuit somewhere that is causing the fuse to blow. To determine where the short is start by disconnecting the trailer from the tow vehicle. Replace the fuse and then use a circuit tester such as #PTW2992 to test the vehicle side…

view full answer...

Answer 10

We have exactly what you need. For the amber lens light you would want the Oval Clearance Light part #MC38AB and then for the red light you would want the Peterson Red Oblong Clearance Light part #423000.

view full answer...

Answer 11

The issue you are having still sounds like there might be a weak or bad ground on the new LED lights. The mix between them and the incandescent assemblies at the rear of the trailer should not be causing this problem so it has to be something…

view full answer...

Answer 12

SAE numbers aren't part numbers so it's hard to pick out replacement lights based on of them since that's not info that's stored as a cross reference. We've had customers with a similar number SAE-AP2-79 which turned out to be the…

view full answer...

Replacement Trailer Clearance Light for a Haulmark Trailer

Product Page this Question was Asked From

Continue Researching