Brake Magnet Recommendation For 10k Axle Brake Hubs  

Question:

Expert Reply:

I did look at your purchase history and Dexter Trailer Brake Drum for 9,000-lb to 10,000-lb Axles - 12-1/4" - 8 on 6-1/2 - Non-ABS # 9-44-1 was purchased here. Thank you!

If the magnets are bad and need replacing, the Dexter 10,000 lb trailer axle brake magnet part # BP01-301 will work but just putting new ones on will not really help in the braking performance. You would really want to do a brake adjustment using the Brake Adjustment Spoon for Drum Brakes # W80630 or review the settings on your brake controller if you're using one.

The drum brake adjuster is located under an access cover in the back of the drum brake. Turn the star-shaped adjuster a few times and if it doesn't stop turning due to the pads hitting the drum, then turn the star in the other direction. After the pads hit the drum, back the star wheel off by one click. Spin the drum with your hand and feel for any drag. The drum should spin freely with very minimal drag. If too much drag is present, then back off the star adjuster slightly. Do this in small increments until the brake is adjusted to where you would like it to be. Repeat this procedure on the other side of the vehicle.

I have included review and installation videos as additional resources to help get you started.

expert reply by: Patrick R

0