Which Valterra Sewer Slip Hub Fits Over a 2 inch Pipe

Question

Question:

Does this t1005-1 part fit over a 2inch pipe. Do you have the measurement?

asked by: Michael B

1

Helpful Expert Reply:

The Valterra RV Sewer Slip Hub with Flange # T1005-1 can fit into a 2 inch pipe or over a 1-1/2 inch pipe. For a similar adapter that fits over a 2 inch pipe you'd want the part # T1005-2 instead.

expert reply by: Jameson C

1

Answer 1

The Provider ST205/75R15 Radial Trailer Tire with 15" Vesper Silver Mod Wheel #TA93MR has an 81 mph speed rating so you'll be good to go there. When it comes to the bolt pattern you'll measure from the center of one bolt hole to the…

view full answer...

Answer 2

I went out to the warehouse to measure Valterra RV Sewer Spigot with Flange - 1-1/2" Item #T1006-1 for you. The holes are spaced 2-7/16 inches apart on center up and down and side to side. Diagonally they are space 3-7/16 inches apart on center.…

view full answer...

Answer 3

Per specs available to me, the Parallax 7400 Series converter charger has a 55 Amp rating. The Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger, #PD9260C is a 60-Amp output and confirmed to be a valid replacement. This smart…

view full answer...

Answer 4

You should be able to tell which Valterra Double RV Waste Valves you need by inspecting your current connection points. The one end with the lugs on it is the same on all 3 parts so you simply need to determine if you need hubs, spigots, or a…

view full answer...

Answer 5

Yes, the Advent Air RV Air Conditioner part #ACM135 is a direct replacement for the Duo-Therm Brisk Air Air Conditioner and you can reuse your existing ceiling vent and thermostat. There are no adapters needed for this either.

view full answer...

Answer 6

The abs cement isn't going to come loose and will require you to cut the pipe a bit further back and using a coupling #D50-2935 and more straight pipe to get back to where it originally sat for the valve. That being said, you can also just unbolt…

view full answer...

Answer 7

The non-threaded hub portion of the LaSalle Bristol Swivel Adapter for RV Sink Strainer #344633216 has an inner diameter of 1-5/8" so that it can allow for a 1-1/2" pipe to slip into it. For this attachment you'll want to use LaSalle…

view full answer...

Which Valterra Sewer Slip Hub Fits Over a 2 inch Pipe

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching