Does Solera Smart Arm 12V Power RV Awning Conversion Kit Require Separate Endcap Order

Question

Question:

do you need to buy the solera endcaps separately or do they come with the kit? I dont see them in the pictures. can these arms be installed without the solera endcaps?

asked by: Johnathan S

0

Expert Reply:

The Solera Smart Arm 12V Power RV Awning Conversion Kit # LC759405 comes with everything you'd need and would not require you to also purchase endcaps.

expert reply by: Jameson C

0

Answer 1

At this time the Solera Smart Arm RV Awning Conversion kit part #LC759405 does come with end caps that attach to the awning roller. At one point it was left off like the review you mentioned but now they are for sure there.

view full answer...

Answer 2

We have kits like the Solera Smart Arm 12V Power RV Awning Conversion Kit #LC759517 which is designed to convert Lippert, Solera, Dometic, and Carefree manual awnings to power awnings. The install is pretty simple and straight forward but we do not…

view full answer...

Answer 3

Actually the 12 volt Solera awnings are the ones that have the ability to add the wind sensor part #LC715123 and the rain dump sensor #LC715124. You can convert to the 18 volt system if you wanted to with the #LC759404 that you referenced but those…

view full answer...

Answer 4

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 5

The closest manual to power conversion kit that we have to your 73" arms is the Solera Smart Arm 12V Power RV Awning Conversion Kit #LC759405 (for white) or #LC759517 (for black) which are 69". We have contacted the manufacturer in the past…

view full answer...

Answer 6

Yes; the only difference between the Solera Smart Arm #LC759517 and #LC759405 is going to be the color of the arms. You can use either one of these to upgrade your existing A.E. manual awning but you can also use the Solera 12v Power Awning…

view full answer...

Answer 7

Most factory awnings are made by Lippert, but there are a couple other manufacturers have been used. Based on my research your factory awning was made by Carefree and we don't carry that brand but do have replacement options. Based on my research…

view full answer...

Answer 8

You're correct that the kits do come with larger arms so you would have to piece the parts together in order to get arms that will fit the height of your trailer. The smallest length arms we carry are 63" so you could use the Solera Smart…

view full answer...

Answer 9

I do have an option for you but it will involve upgrading your entire awning as the only Roller Tubes #LC260560477 are for a Solera Awning. You can upgrade from your manual awing to a power awing without having to run wiring. The Solera 18V Power RV…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Does Solera Smart Arm 12V Power RV Awning Conversion Kit Require Separate Endcap Order

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching