Dimensions of Load Bars on Malone MPG535 MegaSport Kayak Trailer

Question

Question:

I was wondering if you could tell me width and height of the crossbars on this Malone trailer? It looks like it is 1inch or maybe 1.25inch square. Thank you!

asked by: Pete

0

Expert Reply:

You called it, the crossbars are indeed 1-1/4 inches square by 86 inches long.

expert reply by: Mike L

0

Answer 1

The Malone MegaSport Kayak Trailer part #MPG535 has 86" long crossbars so it will be great for two kayaks and two bikes. That said, you may have to transport the kayaks on their side depending on their width. I have attached some carrier options…

view full answer...

Answer 2

The square crossbars of the Malone Megasport trailer part #MPG535 are compatible with Thule accessories that were designed to fit square bars.

view full answer...

Answer 3

We do have an option similar to the CE Smith Multi Sport Plus Boat and Kayak Trailer with Bunks #CE48870 that will accept a 16 foot flat bottom boat. What you will need is the Malone MegaSport Kayak Trailer #MPG535 with the Bunk Kit for Malone…

view full answer...

Answer 4

Changing a trailer's tire size does not necessarily equal an upgrade. The most useful way to add safety margin to a trailer is to change the Load Range rating of the existing tire size. I will explain why. Heat is a trailer tire's worst…

view full answer...

Answer 5

I looked up the kayaks that you have and estimated that at the most the kayaks together could weigh as much as 328 pounds. This is within the capacity of many trailers we have including the Malone MicroSport #MPG460G. The capacity does not include…

view full answer...

Answer 6

For a kayak trailer that can hold 2 kayaks and is made in the USA you can use the Malone MegaSport Kayak Trailer - 86" Crossbars - 1,000 lbs #MPG535 you were looking at. Keep in mind, this does not come with any kayak carriers so you would need…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Dimensions of Load Bars on Malone MPG535 MegaSport Kayak Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching