Dutton-Lainson # DL22300 or Pro Series # PSEJ10000101 Swivel Jack for 3 x 3 Inch Tongue
Question:
Would a DL22300 or a PSEJ0000101 be the better jack for a 3x3 tongue? Are they both about the same total length and lift? Thanks!
asked by: Mike L
Expert Reply:
Between the two options you mentioned I strongly recommend the Dutton-Lainson Sidewind Swivel Jack # DL22300 for your 3 x 3 inch trailer tongue. This particular unit features a slightly higher capacity of 1,200 pounds compared to 1,000 pounds on the Pro Series # PSEJ10000101, which will allow it to work a bit faster and lead to a longer lifespan. It also features a superior zinc plated yellow chromate TUFFPLATE finish, compared to the standard zinc finish on the Pro-Series, which will do a much better job of resisting rust and corrosion over time.
Both options do indeed have the same 10 inch lift and same relative bracket height of 23 inches when extended. I have attached a couple short video demonstrations that you can check out as well.
Products Referenced in This Question
Pro Series Snap-Ring Swivel Marine Jack - Bolt On - Sidewind - 10" Lift - 1,000 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 0 - 1000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Pro Series
more information >
Product Page this Question was Asked From
Trailer Jack, Sidewind Swivel Jack with 6" Wheel - 1200 lbs. by Dutton-Lainson
- Trailer Jack
- Boat Trailer
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Dutton-Lainson
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: Trailer Lighting Requirements
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Replacement for Dexter Grease Seal 010-019-00
- Q&A: Edge CS2 Evolution Diesel Tuner - How Do I Unpair With An Old Vehicle?
- Q&A: Will Using 2 of the Timbren Axle-Less Trailer Suspension Kits Double the Capacity?
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Replacement Jack for Ranger Boat Trailer With Dutton Lainson 203960C
- Article: How to Measure a Trailer Axle
- Q&A: Does Dutton Lainson Trailer Jack DL22300 Require any Ground Clearance
- Q&A: What is Active Curve System and Recommended Trailer Hitch for 2017 Mercedes-Benz GLE350
- Article: How to Measure for Trailer Hitch Drop
- Article: Best Boat Accessories