Could Lippert Jack It Bike Rack # LC429756 Install in 2 inch Trailer Hitch
Question:
What are the dimensions of the upper vertical receiver on the Jack-It Bike Tower where the angled arm slides into? Is it a standard 2 inch square hole?
asked by: Robert G
0
Expert Reply:
While the square openings you mentioned on the Lippert Jack It part # LC429756 are 2 inch by 2 inch if your plan was to install this in a 2 inch hitch you'd also need the Bump It adapter part # LC723359 designed specifically for this application!
expert reply by:
Jameson C
0
Products Referenced in This Question
Bump-It Hitch Receiver Adapter for Jack-It 2 Bike Rack
- Accessories and Parts
- RV and Camper Bike Racks
- Shanks and Adapters
- Adapters
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Bump-It Hitch Receiver Adapter for Jack-It 2 Bike Rack
- Article: How to Carry Bikes While Towing a Travel Trailer
- Q&A: Bike Rack Recommendation for NuCamp 320 Camper
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: Trailer Wiring Diagrams
- Q&A: Recommended AC With Heat Strip for Enclosed Trailer
- Q&A: Bike Rack Solution for Carrying Bikes between Tow Vehicle and Camper
- Q&A: Straight Stinger for Jack-It 2 Bike Rack for A-Frame Trailers
- Q&A: Orientation of Jack-It 2 Bike Rack for A-Frame Trailers Installed on Camper Trailer
- Q&A: Fitment of the Hitch-It 2 # LC731138 to a 10" Straight Trailer Tongue
- Q&A: Converting a Hymer Touring GT Camper from Surge to Electronically Controlled Brakes
- Article: Rooftop Cargo Carriers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Best Bike Racks for Electric Bikes